User manual AEG BWS 12 C

[. . . ] Read all safety warnings and all instructions, including those given in the accompanying brochure. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. [. . . ] use only System PCLS chargers for charging System PCLS battery packs. Do not use battery packs from other systems. Battery acid may leak from damaged batteries under extreme load or extreme temperatures. In case of contact with battery acid wash it off immediately with soap and water. In case of eye contact rinse thoroughly for at least 10 minutes and immediately seek medical attention. SPECIFIED CONDITIONS OF USE The Maschine can be combined with different tools and is designed for following use: Right Angle Head: for drilling and screwing in wood, metal and plastics. Sander Head: sanding wood, metal and plastics Segment saw blade head: for cutting flush to a surface in wood and plastics. universal blade head: for working in wood. Do not use this product in any other way as stated for normal use. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. BATTERIES New battery packs reach full loading capacity after 4 - 5 chargings and dischargings. Battery packs which have not been used for some time should be recharged before use. The contacts of chargers and battery packs must be kept clean. BATTERY PACK PROTECTION The battery pack has overload protection that protects it from being overloaded and helps to ensure long life. under extreme stress the battery electronics switch off the machine automatically. To restart, switch the machine off and then on again. If the machine does not start up again, the battery pack may have discharged completely. In this case it must be recharged in the battery charger. [. . . ] However if the tool is used for different applications, with different accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. [. . . ]