User manual AEG FL 12

[. . . ] 19 20 42 20 24 9 17 41 12 Fig. 31 33 47 49 50 48 52 51 53 48 Fig. It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications. GENERAL POWER TOOL SAFETY WARNINGS h. [. . . ] If shipping has influenced the settings, refer to specific procedures explained in this manual. WARNING If any parts are damaged or missing, do not operate this tool until the missing parts are replaced. Failure to heed this warning could result in serious personal injury. 5 bag and slide it on the dust guide. The metal ring in the bag should lock in between the grooves on the dust guide. To remove the dust bag for emptying, simply reverse the above procedure. WORK CLAMP See Figure 10. blade washer. Wipe a drop of oil onto the inner blade washer and the outer blade washer or laser guide where they contact the blade. WARNING If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly. WARNING In some operations, the work clamp assembly may interfere with the operation of the blade guard assembly. Always make sure there is no interference with the blade guard prior to beginning any cutting operation to reduce the risk of serious personal injury. The work clamp provides greater control by clamping the workpiece to the fence. It also prevents the workpiece from creeping toward the saw blade. This is very helpful when cutting compound mitres. NOTE: The blade bolt has left hand threads. Do not remove the inner DANGER Laser radiation. Avoid direct eye contact with light source. ALIGNING THE LASER GUIDE LINE See Figure 12. The laser guide will generate a colored line on the work surface when the blade is spinning. The laser line will appear as a broken line on the workpiece when the blade assembly is in the uppermost position and the motor switch is activated. This broken line will let you see your mark and your laser guide line at the same time, and will assist you in lining up your mark for more accurate cutting of the workpiece. To cut your mark: Using a sharp pencil, mark a line on the workpiece. With the saw blade in the uppermost position, align the laser line with your mark. Once both lines are in alignment, do not move the workpiece until after you have finished cutting. NOTE: As the saw blade assembly is lowered toward the workpiece, the broken line will become solid. 5. 6. 6 line will drift away from the mark as the saw blade gets closer to the workpiece. [. . . ] Use the work clamp to secure the workpiece. NOTE: When making a compound mitre cut, it may be necessary to adjust or remove the sliding mitre fence to insure proper clearance prior to making the cut. When cutting wide workpieces, boards should be clamped with the work clamp. CUTTING COMPOUND MITRES To aid in making the correct settings, the compound angle setting chart below has been provided. [. . . ]