User manual AEG H 500

[. . . ] SAFETY INSTRUCTIONS Please pay attention to the safety instructions in the attached leaflet!Exposure to noise can cause hearing loss. Appliances used at many different locations including open air must be connected via a current surge preventing switch. [. . . ] The protective swing cover and the blade drive cover on the side must be easy to move to and fro. The protective swing cover must not be locked open except when the plane is beeing used in a fixed mounting. Protective swing guard operation only with the provided lever or automatically by the workpiece. In the fixed position, the plane may only be used in the AEG stationary mounting or in the AEG dressing and planing table. Do not put the machine down until the blade drive has stopped running. Never reach into the danger area of the plane when it is running. The dust that arises when working with this tool can be detrimental to health (e. When working oak or beech wood, stones, paint, which could contain lead or other harmful chemicals) and therefore not reach the body. Use a dust absorption system and wear a suitable dust protection mask. Do not use this product in any other way as stated for normal use. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. accessory - Not included in standard equipment , available as an accessory. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. Never reach into the danger area of the plane when it is running. Place the front page of the machine on to the worpiece and switch on, before the planer blade touches the workpiece and then guide evenly over the workpiece. The selv opening swivel guard should be lifted only by the workpiece or with the lever. [. . . ] Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the tool can be ordered. As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. [. . . ]