User manual AEG HL

[. . . ] 6 choke lever ON OFF ON OFF to start (choke closed) fuel valve to run (choke open) Fig. 8 latches air filter unit air filter cover Fig. 10 spark plug ON OFF fuel valve filter o-ring sediment cup spark plug cap Fig. 12 fuel line fuel valve ON OFF ON OFF barb Fig. [. . . ] OIL DRAINAGE BOLT When changing the engine oil, the oil drainage bolt is loosened to allow old engine oil to be drained. OIL CAp/DIpsTICK Remove the oil fill cap to check and add oil to the generator when necessary. AssEmBLy UNpACKING n This product has been shipped completely assembled. Remove one end of the box and carefully slide out the generator and any accessories. NOTE: The generator is heavy. If you must lift the unit out of the box, get another person to help you and lift with your legs, not your back. n Inspect the unit carefully to make sure no damage occurred during shipping. n n If any parts are damaged or missing, please contact your nearest authorised service centre for assistance. Do not discard the packing material until you have carefully inspected and satisfactorily operated the product. pACKING LIsT Generator Oil Bottle / Oil Funnel Operator's Manual Spark Plug Wrench Wheel 8 English WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury. WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. AppLICATIONs This generator is designed to supply electrical power for operating compatible electrical lighting, appliances, tools, and motor loads. BEfORE OpERATING THE UNIT Position the generator on a flat surface before checking fluid levels or adding fluid. CAUTION: Attempting to start the engine before it has been properly filled with oil will result in equipment failure. WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. CHECKING/ADDING fUEL See Figure 5. If fuel is needed, continue with the next step. n Fill the fuel tank to 25mm below the top of the fuel neck. NOTE: Always use unleaded gasoline with a pump octane rating of 86 or higher. Never use old, stale, or contaminated unleaded fuel, and do not use an oil/gas mixture. Do not allow dirt or water into the fuel tank. n 9 English UsING fUEL sTABILIsER Fuel gets old, oxidizes, and breaks down over time. Adding a fuel stabiliser extends the usable life of fuel and helps prevent deposits from forming that can clog the fuel system. Follow fuel stabiliser manufacturer's directions for correct ratio of stabiliser to fuel. n n n Add stabiliser to fuel tank, then fill with unleaded fuel following previous instructions. NOTE: Fuel stabiliser and unleaded fuel can be mixed prior to filling the tank by using a gas can or other approved fuel container and shaking gently to combine. Start and run the engine for at least 5 minutes to allow stabiliser to treat the entire fuel system. NOTE: Some conventional petrol are blended with alcohol or an ether compound. [. . . ] However, if the knocking or pinging occurs under normal load at a steady engine speed, the problem may be with the brand of unleaded fuel being used. Switch to a different brand of unleaded fuel, making sure that the octane rating is 86 or higher. If problem continues, contact your nearest authorized service center. If problem persists after trying the above solutions, contact your nearest authorized service center for assistance. The following symptoms may indicate problems that will affect the emissions level of the unit: Hard starting or stalling after starting Rough idle Misfiring or backfiring under load Afterburning (backfiring) Black exhaust smoke or high fuel consumption n n n n n If you encounter any of these symptoms, have the unit inspected and repaired by the nearest authorized service center. 14 WIRING DIAGRAm - AGN6000DB English 15 LImITED WARRANTy TTI warrants this outdoor product to be free of defects in material and workmanship for 24 months from the date of purchase by the original purchaser, subject to the limitations below. Please keep your invoice as proof of date of purchase. [. . . ]