User manual AEG LF 650

[. . . ] J Do not pierce the motor housing as this could damage the double insulation (use adhesives). J Always disconnect the plug from the socket before carrying out any work on the machine. Only plug-in when machine is switched off. J Keep mains lead clear from working range of the machine. [. . . ] Spindle lock to lock working spindle for exchanging router cutters. Auxiliary handle On­/Off switch built as a large slide. After unlocking the left clamping lever the swivel fence can be adjusted infinitely variable. Swivel fence with height adjustment After unlocking the right clamping lever the height of the swivel fence can be adjusted infinitely variable. Base plate with markings for easy cutting Depth guide to pre­set three different board thicknesses Sawdust ejector, can be connected with a suction nozzle or a by­pass nozzle modifications: Text , diagrams and data are correct at the time of printing. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. The size of the biscuit dowels to be used depends on the thickness of the material. Always use biscuit dowels of the biggest possible size to ensure a solid joint. If the working material is thicker than 25 mm, use 2 biscuit dowels on top of each other. Set the cutting depth with the adjustment knob according to the chosen biscuit dowel to be used. Unlock the left clamping lever, set the swivel fence with aid of the scale to the required angle (e. 5o) can be quickly adjusted with aid of notched stages. To be able to cut the groove for the biscuit dowel centrically, the joiner must be pre­set to the board thickness. Unlock the right clamping lever, set the swivel fence with aid of the scale to the required board thickness, and re­fasten the clamping lever. The values on the scale are only applicable when the push­on plate is fitted. Should the locked clamping lever be in the way when working with the tool, fasten it in a different position by pulling it out without unlocking it. Three board thicknesses can be pre­set at the depth guide. Should the locked clamping lever be in the way when working with the tool, fasten it in a different position by pulling it out without unlocking it. Place the two boards to be joined on top of each other (flush), fix them with screw­clamps and mark the center of the grooves. The distance between the grooves should be 10­15 cm. Depending on the width of the boards the machine can be positioned in different ways. Wide boards: Position the machine to the workpiece such that the base plate middle marking is facing the board marking. [. . . ] Maintenance The ventilation slots of the machine must be kept clear at all times. Use only AEG accessories and spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the tool can be ordered. [. . . ]