User manual AEG MDE 1200

[. . . ] J Always wear goggles when using the machine. It is recommended to wear gloves, sturdy non slipping shoes and apron. J Sawdust and splinters must not be removed while the machine is running. J Do not pierce the motor housing as this could damage the double insulation (use adhesives). [. . . ] Mounting plate for oil feed contain ( Accessory) Tool clamp Speed preselection Robust rack guide for high load transmission Adjustable carriage guide Carrying handle Advancing lever In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Always disconnect the plug from the socket before carrying out any work on the machine. The carriage is adjusted by the factory such that it will stop in any position and not move down by the weight of the machine. In case that the carriage play must be adjusted, proceed as follows: Loosen the locking nuts with fork wrench SW8, adjust the carriage play with Allen key size 2. 5 , and re­tighten the locking nuts. Secure the magnetic drill stand with the provided chain when working slanting or vertical surfaces, or overhead such that it won't fall down in case of power loss. The safety chain must be applied such that the drill stand will move away from the user in case of power loss. Starting to work Switching on the stand For optimum operating safety the magnetic drill stand is equipped with a main switch. Depress the yellow push­button for magnetic field to build up. Switching off Switching off the machine Depress the green push­button. The magnetic field dies away after approx. Release the black buttom Magnet and machine will turn off! For safety reasons, the push-button of the main switch is recessed when switched on. If the machine is not used for a longer period while the magnetic field is activated, a short­interval signal tone indicates this state every 5 minutes. Motor protection device controlled by motor load ­ heat controlled shut-off if overloading is great. The machine will slowly continue to run in order to cool the motor down. After sufficient cooling machine can be restarted by switching off and on again. The table shows standard values when using core hole drills. Inserting tools Always disconnect the plug from the socket before carrying out any work on the machine. Fasten the core hole drill bit with the two If necessary, remove any unevennesses as well as welding leftovers. a thin layer of grease does not matter. Punch­mark the spot to be drilled and apply the drill stand with the drill tip above the punch mark. [. . . ] The bearings of the feed shaft are self­cutting and must not be greased. grease the sliding surface of the carriage with Molykote grease. Use only AEG accessories and spare parts. Should components need to be exchanged which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). [. . . ]