User manual AEG MFE 1305

[. . . ] Repairs should only be carried out by authorised service agents. S After switching off, the machine will not be idle immediately. S Never reach into the danger area of the machine when it is running. S Always wear safety goggles and ear protectors when working with this machine. [. . . ] Under the effect of extreme electromagnetic interferences from the outside, temporary variations in the speed of rotation could arise in particular cases. The electronic smooth start will prolong the life of both the motor and the gears. Therefore do not run the machine under load for 2 sec. Electronic speed adjustment ensures constant speed even when the load on the motor varies. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. To lock, depress the front part of the switch. Only use the machine with a suitable dust-remover!Insert the suction hose connector into the adapter until it sits firmly. Connect the other end of the suction hose to a vacuum cleaner which is suited for dust extraction. We recommend the use of powerful industrial vacuum cleaners. They are suited for sucking off large quantities of stone dust and allow the machine to be connected directly to the socket of the vacuum cleaner. When the machine is switched on the vacuum cleaner starts automatically. Always disconnect the plug from the socket before carrying out any work on the machine. Screw out screw and take out cutting support downwards. Screw out screw and take off protective hood cover. Lock the work spindle by depressing the spindle lock. Pull off diamond cutting discs and spacing washers from the bearing flange. Fit the new diamond cutting discs together with the spacing washers and tighten the flange nut with the two hole spanner. The number of spacing washers between the diamond cutting discs determines the cutting width. Arrow on diamond cutting discs must agree with arrow on protective hood cover-direction of rotation. use the diamond cutting discs appropriate to the type of masonry. Fit protective hood cover and support guide and set the cutting depth with the starshaped knob. [. . . ] Use only AEG accessories and spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the tool can be ordered. As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D-71361 Winnenden. [. . . ]