User manual AEG MSC 305

[. . . ] MSC305 305 mm COMPOUND MITRE SAW WITH LASER ORIGINAL INSTRUCTIONS N197 20 1 19 2 13 3 18 4 24 17 5 6 16 7 15 8 14 11 12 Fig. 8 30 16 28 24 29 TO LOOSEN 31 TO TIGHTEN Fig. 14 46 24 17 12 35 9 Fig. 15 36 17 24 35 37 12 Fig. [. . . ] Place the shaft of the work clamp in either hole on the saw table base. Rotate the knob on the work clamp to move it in or out as needed. NOTE: The work clamp has a quick release lever that makes positioning of the work clamp effortless. Fit saw blade inside upper blade guard and onto spindle. The blade teeth point downward at the front of saw. CAUTION Always install the blade with the blade teeth and the arrow printed on the side of the blade pointing down at the front of the saw. The direction of blade rotation is also stamped with an arrow on the upper blade guard. The double "D" flats on the blade washers align with the flats on the spindle. Depress spindle lock button and replace blade bolt. NOTE: The blade bolt has left hand threads. Turn blade bolt counterclockwise to tighten. Lower the blade guard and blade bolt cover. Replace screw and tighten securely. WARNING Make sure the spindle lock button is not engaged before reconnecting saw into power source. Never engage spindle lock button when blade is rotating. WARNING A 305 mm blade is the maximum blade capacity of the saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guards, while thicker blades will prevent the blade bolt from securing the blade on the spindle. Either of these situations could result in a serious accident and can cause serious personal injury. NOTE: Check the blade carefully for cracks or damage before operation. Replace cracked or damaged blade immediately. Rotate blade bolt cover up and back to expose the blade bolt. Depress the spindle lock button and rotate the blade bolt until the spindle locks. Using the wrench provided, loosen and remove the blade bolt. NOTE: The blade bolt has left hand threads. [. . . ] Since compound cuts are the most difficult to accurately obtain, trial cuts should be made in scrap material, and much thought and planning made, prior to making your required cut. CUTTING WARPED MATERIAL See Figures 30 - 31. When cutting warped material, always make sure it is positioned on the mitre table with the convex side against the fence. If the warped material is positioned the wrong way, it will pinch the blade near the completion of the cut. CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. WARNING When servicing, use only identical replacement parts. [. . . ]