User manual AEG OFE 710

[. . . ] J Sawdust and splinters must not be removed while the machine is running. J Do not pierce the motor housing as this could damage the double insulation (use adhesives). J Always disconnect the plug from the socket before carrying out any work on the machine. Only plug-in when machine is switched off. [. . . ] Locking screw to fix the motor: After loosening the screw the motor can be removed from the cage and be used as a straight grinder. Parallel guide for parallel cutting with a distance of up to 240 mm from edge. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Always disconnect the plug from the socket before carrying out any work on the machine. exchanging router cutters The collet diameter must be corresponding to the shaft diamter. Nsert the shaft of the tool as far as possible into the collet and tighten with clamping nut. To take out router cutter, loosen adjusting nut until the cutter can be removed. The following collets can be used: ø 6 mm, ø 8 mm, ø 1/4"* (The ø relates to the shaft diameter of the router). Push a new collet into adjusting nut until it Screw adjusting nut with collet onto After setting the required distance from the edge tighten the wing screws. For close cutting of boards coated on one or both sides, the plastic corner guides are screwed on, as figure. Insert the precision adjustment screw (B) fromthe right or left into the base plate. Adjust the cutting distance roughly and tighten screw (A). By turning the screw socket set the clearance exactly. Check the settings with a test cut and make possible corrections with aid of fine adjustment. Industrial vacuum cleaners as well as household vacuum cleaners are suitable. Only operate the machine with suitable sawdust removal. Device turning it slightly and connect the other end of the hose with a vacuum cleaner. the suction device has a standardized inner diameter of 26 mm. Any suction hose with the same diameter can be used (e. Lower cage until the router cutter Lower the depth gauge onto the required Pick value off the scale, add required Three cutting depths can be set with the screws on the revolving depth gauge: Set the first two cutting depths on the longer screws. tighten screws again and Secure with the locking nuts against distorting. For cutting, lower the cage to the longest screw and tighten. [. . . ] In order to guarantee constant readiness for operation, the machine should be checked for worn carbon brushes at one of the AEG after­sales service agencies. Use only AEG accessories and spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the tool can be ordered. [. . . ]