User manual AEG PNEUMATIC 5000 E

[. . . ] Please read the instructions for use before first operation so you can handle your power tool effectively and safely. We are sure that buying an AEG Electric Power Tool from Atlas Copco was the right choice!Advice for your safety Please pay attention to the safety instructions in the attached leaflet!Appliances used at many different locations including open air must be connected via a current surge preventing switch. [. . . ] When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow. The impact needed for hammer drilling in stone is created by a pneumatic hammer striking mechanism. Similar to hitting a common chisel with a hammer, a plunger hits the axially moving chisel. The electric motor moves the plunger back and forth crank drive ­> piston ­> freely moving piston. There is a pneumatic cushion between piston and freely moving piston (pneumatic hammer mechanism). this results in a highly effective hammering action. Exerting greater power does not increase the machine's effectiveness. Anti Vibration System AVS The hammer mechanism and motor are independant of the handgrips, cushioning elements absorb vibrations on both handgrips when hammering and chiselling. Hammer drilling chuck for bits and accessories with SDS-max reception ­ tools are locked automatically after insertion. Built-in safety clutch helps prevent the machine from rotating if the drill bit jams. Switch trigger for switching the machine on and off, and for smooth starting and varying speed. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. Switching on: Press switch trigger Switching off: Release switch trigger The speed can be infinitely varied by slowly releasing/pressing the switch trigger. Always disconnect the plug from the socket before carrying out any work on the machine. The following tools can be inserted in the drill-hammer chuck using the SDS-max shank: ­ Hammer-drill for concrete and brickwork ­ Pointed chisel, flat chisel, hollow chisel, tile chisel Only use accessories with SDS-max shank!Push bit into chuck turning it slightly, the It must be possible to move it back and forth. Switching between hammer drilling, chiselling Depending on the inserted tool the machine can be operated with additional rotation (SDS­max­drills) or without additional rotation (SDS­max­chisels). In "free turning position" the chisel can be turned by hand to the required angle. Afterwards lock the spindle with the selector lever while turning the chisel slightly. [. . . ] Use only AEG accessories and spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the tool can be ordered. As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320, D­71361 Winnenden. [. . . ]