User manual AEG SCB51811LS

[. . . ] Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. visit our website for: Get usage advice, brochures, trouble shooter, service information: www. [. . . ] The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre. Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not observed. The airflow behind the appliance must be sufficient. Refer to the assembly instructions for the installation. To turn off the appliance, turn the temperature regulator to the "O" position. Toward lower settings to obtain the minimum coldness. Turn the Temperature regulator toward higher settings to obtain the maximum coldness. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature , · How often the door is opened , · The quantity of food stored , · The location of the If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Before using the appliance for the first time, the interior and all internal accessories should be washed with Lukewarm water and some neutral soap to remove the typical smell of a brandnew product, then dried thoroughly. Do not use detergents, abrasive powders, chlorine or oil-based cleaners as they will damage the finish. To permit storage of food packages of various sizes, the door shelves can be placed at different heights. Gradually pull the shelf up until it For proper storage of food the refrigerator is equipped with the temperature indicator. The symbol on the side wall of the appliance indicates the coldest area in the refrigerator. If OK is displayed (A), put fresh food into area indicated by symbol, if not (B), adjust the temperature controller to a colder setting and wait 12 hours before checking the temperature indicator again. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Do not move the glass shelf above the vegetable drawer to ensure correct air circulation. After putting fresh food into the appliance or after opening the door repeatedly or for a long period, it is normal for the indicator not to show OK. [. . . ] Water flows inside the refrig- Food products prevent the Make sure that food products Water to flow into the wa- do not touch the rear plate. The melting water outlet is not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray. The temperature in the appliance is too low/too high. [. . . ]