User manual AEG SE 12-180

[. . . ] loss of control can cause personal injury. Appliances used at many different locations including open air must be connected via a current surge preventing switch. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Contact with a , , live" wire will also make exposed metal parts of the power tool , , live" and shock the operator. [. . . ] The mounting hole diameter must fit the mounting flange without play. The grinding tool must be properly mounted and turn freely. Perform a test run for at least 30 seconds without load. Do not use damaged, out of round or vibrating grinding tools. Immediately switch off the machine in case of considerable vibrations or if other malfunctions occur. Check the machine in order to find out the cause. Always use and store the grinding disks according to the manufacturer's instructions. When grinding metal, flying sparks are produced. Take care that no persons are endangered. Because of the danger of fire, no combustible materials should be located in the vicinity (spark flight zone). Due care should be taken that no sparks or sanding dust flying from the workpiece come into contact with you. The adjusting nut must be tightened before starting to work with the machine. The workpiece must be fixed if it is not heavy enough to be steady. Never lead the workpiece to the grinding disk with your hand. Smooth-grinding metals with the arbour and vulcanized fibre grinding wheel), significant contamination can build up on the inside of the angle grinder. For safety reasons, in such conditions the inside should be cleaned thoroughly of metal deposits and a motor circuit-breaker must be connected in series. if the motor circuit-breaker trips the machine must be sent for repair. For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length. [. . . ] Should components need to be replaced which have not been described, please contact one of our Milwaukee service agents (see our list of guarantee/ service addresses). If needed, an exploded view of the tool can be ordered. As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Milwaukee Electric Tool, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. SYMBOLS Please read the instructions carefully before starting the machine. [. . . ]