User manual AEG WS 1200-125 X

[. . . ] It is recommended to wear gloves, sturdy non slipping shoes and apron. Do not pierce the motor housing as this could damage the double insulation (use adhesives). Always disconnect the plug from the socket before carrying out any work on the machine. [. . . ] Only plug-in when machine is switched off. Only use diamond cutting discs that are sharp and in perfect condition. Replace diamond cutting discs at once if they have splits or are deformed. When cutting stone, a guide has to be used. Always use guard when grinding or cutting. Due care should be taken that sparks flying from the work piece do not contact inflammable materials. Before setting the machine into motion tighten flange nut. When the machine is used under extreme humid conditions or is very contaminated with conductive dusts, we recommend the use of an ELCB safety switch (earth leakage circuit breaker) to increase your personal safety. Typically the A-weighted sound pressure level of the tool is 85 dB (A). When the thickness of the disc is less than 5, 5 mm use the flange nut with the flat side against the grinding disc. The range of accessories with part numbers is shown in our catalog. Connect only to a single-phase AC current supply and only to the mains voltage specified on the rating plate. When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol or coloured green or green/yellow. The ventilation slots of the machine must be kept clear at all times. Use only AEG accessories and spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). If needed, an exploded view of the tool can be ordered. [. . . ] If needed, an exploded view of the tool can be ordered. As well as the machine type printed on the label and order the drawing at your local service agents or directly at: Atlas Copco Elektrowerkzeuge GmbH, Postfach 320, D­71361 Winnenden. Intermittant Use Switching on: Push forward on­off control (LEERER MERKER) without pressure Switching off: Release on­off control Continuous Use Switching on: Push forward on­off control wSL 115 XS , WSL 125 X , WS 100 S , WS 115 S , WS 1200-125 X Modifications: Text , diagrams and data are correct at the time of printing. [. . . ]