User manual AEG WS 24-230 GVX

[. . . ] Please read and save these instructions!Use a spanner wrench if FIXTEC nuts are stuck. Switch can be locked Schalter ist arretierbar Le commutateur peut être verrouillé L`interruttore si può bloccare El interruptor se puede bloquear. Alter ayarlanabilir Vypínac je aretovatelný Vypínac je aretovatený Przelcznik daje si zablokowa A kapcsoló rögzíthet Stikalo je nastavljivo Prekidac se moze aretirati Sldzis ir labojams Jungiklis gali bti uzblokuojamas Lüliti on fikseeritav Comutatorul poate fi blocat Switch cannot be locked Schalter ist nicht arretierbar Le commutateur ne peut pas être verrouillé L`interruttore non si può bloccare El interruptor no se puede bloquear. [. . . ] O) Do not operate the power tool near flammable materials. p) Do not use accessories that require liquid coolants. Using water or other liquid coolants may result in electrocution or shock. Kickback and Related Warnings Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any other accessory. Pinching or snagging causes rapid stalling of the rotating accessory which in turn causes the uncontrolled power tool to be forced in the direction opposite of the accessory's rotation at the point of the binding. For example, if an abrasive wheel is snagged or pinched by the workpiece, the edge of the wheel that is entering into the pinch point can dig into the surface of the material causing the wheel to climb out or kick out. The wheel may either jump toward or away from the operator, depending on direction of the wheel's movement at the point of pinching. Abrasive wheels may also break under these conditions. Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below. A) Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback forces. Always use auxiliary handle, if provided, for maximum control over kickback or torque reaction during start-up. The operator can control torque reactions or kickback forces, if proper precautions are taken. B) Never place your hand near the rotating accessory. C) Do not position your body in the area where power tool will move if kickback occurs. kickback will propel the tool in direction opposite to the wheel's movement at the point of snagging. D) Use special care when working corners, sharp edges etc. E) Do not attach a saw chain, woodcarving blade or toothed saw blade. such blades create frequent kickback and loss of control. Safety Warnings Specific for Grinding and Abrasive Cutting-Off Operations: a) Use only wheel types that are recommended for your power tool and the specific guard designed for the selected wheel. Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe. B) The guard must be securely attached to the power tool and positioned for maximum safety, so the least amount of wheel is exposed towards the operator. The guard helps to protect operator from broken wheel fragments and accidental contact with wheel. [. . . ] The wire bristles can easily penetrate light clothing and/or skin. B) If the use of a guard is recommended for wire brushing, do not allow any interference of the wire wheel or brush with the guard. Wire wheel or brush may expand in diameter due to work load and centrifugal forces. Appliances used at many different locations including open air must be connected via a residual current device. [. . . ]