User manual AEG WS 7-115 M

[. . . ] Appliances used at many different locations including open air must be connected via a current surge preventing switch. Always wear goggles when using the machine. It is recommended to wear gloves, sturdy non slipping shoes and apron. [. . . ] Perform a test run for at least 30 seconds without load. Do not use damaged, out of round or vibrating grinding tools. Immediately switch off the machine in case of considerable vibrations or if other malfunctions occur. Check the machine in order to find out the cause. Always use and store the grinding disks according to the manufacturer's instructions. When grinding metal, flying sparks are produced. Take care that no persons are endangered. Because of the danger of fire, no combustible materials should be located in the vicinity (spark flight zone). Due care should be taken that no sparks or sanding dust flying from the workpiece come into contact with you. When separating stone the guide shoe must be used!The adjusting nut must be tightened before starting to work with the machine. The workpiece must be fixed if it is not heavy enough to be steady. Never lead the workpiece to the grinding disk with your hand. When smoothing metals with the supporting disk and vulcanised fibre disks) strong contamination can build up inside the angle grinder. In this case, it is necessary to clean the inside thoroughly and free it from any metal deposit, due to safety reasons. a residual current operated device must be superposed. [. . . ] As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. SYMBOLS Please read the instructions carefully before starting the machine. Always wear goggles when using the machine. [. . . ]