User manual AGA LEGACY 36

[. . . ] Dual Fuel Range Users Guide & Installation Instructions This book contains many important safety messages. Always read and obey all safety messages. Installer:Leave these instructions with the appliance U104601-01 www. aga-ranges. com WARNING If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS Do not try to light any appliance. [. . . ] Mildly abrasive cleaner such as Bon-Ami® or Soft Scrub® with a soft cloth Hot soapy water and soft cloth. Branded oven cleaner suitable for enamel surfaces. Non-abrasive cleaner, hot soapy water, soft cloth Dishwasher. Dishwasher Mildly abrasive cleaner Scouring Pad Mildly abrasive cleaner such as Bon-Ami® or Soft Scrub® with a soft cloth. Take care to not damage rubber door seal. Multi-surface Cleaner, soft cloth Carefully read and follow the manufacturers instructions on cleaning products. 22 Using your Range Cooktop burners Some models have a separate trim ring, which fits on the burner head. The burner heads and caps can be removed for cleaning. Make sure they are absolutely dry before replacing. The central cooktop When reassembling the Wok burner, turn over the large base ring and find the `D' shaped area. Turn the head until the `D' matches the one on the burner base. Turn the head over and place it on the burner base. To fit the small inner burner, find the larger electrode notch in the burner rim. Line this up with the white ignition electrode and place the inner burner on the large base ring. A cap, B head, C notch, D base, E electrode When refitting the burner head, make sure that the notch lines up with the electrode or hole in the base. Check that the burner head is level and that the cap is fitted centrally on the burner head. Normal flame appearance Burner not fitted correctly A electrode notch B ignition electrode The Wok burner The Wok burner is a little more complicated but can also be taken apart for cleaning. Now fit the two trim rings, making sure that they are sitting down properly. Broiler The broiler pan and grid should be washed in hot soapy water. After cooking meats or any foods that soil, leave to soak for a few minutes in the sink immediately after use. Stubborn particles may be removed from the grid by using a nylon brush. Control Panel and Doors Avoid using any abrasive cleaners including cream cleaners, on brushed Stainless Steel surfaces. For best results use a liquid detergent. The control panel and control knobs should only be cleaned with a soft cloth wrung out in clean hot soapy water. Wipe with a clean dampened cloth then polish with a dry cloth. The oven doors should only be cleaned with a soft cloth wrung out in clean hot soapy water. Wok burner A inner burner cap, C inner burner head E Wok burner base B D outer burner cap outer burner head 23 Using your Range Ovens The main oven side lining panels can be removed for cleaning and for cleaning behind. Each side of the oven is fixed with four fixing screws. You don't have to remove the screws to remove the oven linings. Lift each side panel upwards and they will slide off the screws. [. . . ] This instruction must be used in conjunction with the rest of the appliance instruction, in particular for information on Standards, range positioning, connection hose suitability etc. When servicing or replacing gas-carrying components disconnect from gas before commencing operation and check appliance is gas sound after completion. Do not use re-conditioned or unauthorised gas controls. Valve adjustment Pull off all the control knobs. If the hand rail has been fitted remove it - remove the plastic blanking plugs and remove the 2 end bracket fixing screws. Remove the 2 cross headed screws that were hidden by the hand rail end brackets. Open the oven door & or broiler door and remove the fixing screws underneath the control panel. Lower control panel clear. Orifices Standard burner Wok burner A valve bypass screw Take out the bypass screw and replace with the correct new screw on each gas control. [. . . ]