User manual AIPTEK DUO-V33F

[. . . ] When using a PC to charge the battery, do not power on the camcorder, or the charge will stop. In addition to the built-in flash memory, your camera can store data on a Secure Digital (SD) card or a MultiMedia card (MMC). to insert a memory card , do the followings: (1) Open the battery cover. (2) Gently push the card as indicated until the card reaches the bottom of the slot. [. . . ] A positive value indicates the image will be brighter than usual; while a negative value makes the image dimmer. After the selftimer is turned on, the camera will have ten seconds delay before recording when the Shutter button is pressed. Enabling this setting allows you to take a photograph with a dark background. Since the shutter speed will slow down when taking photographs at a dark place, we recommend using a tripod to eliminate blurring from hand shake. warning: Noise increases when Night Shot is enabled. This setting allows you to add customsized frames to photos. This setting allows you to combine two images taken individually into one photo. When resolution is set to 10M or above, the "Photo Frame" and "Two-inOne" options, as well as the "16:9 display" function, will not be available. Only JPEG pictures and the first frames of MPEG files will be displayed. Before using the Print command in the menu, you need to connect the camera to a PictBridge compatible printer via the accessory USB cable. A positive value makes the LCD brighter; while a negative value makes the LCD dimmer. Connect the other end of the USB cable to your camcorder. The default is set to "Disk" mode, if you would likt to set other modes as default, please refer to "USB Mode" section for more information. When connected to a PC, the camcorder displays a menu for you to choose a desired connection mode. Notice for Windows 2000/XP users: If you want to disconnect the camcorder from your computer, please follow these steps: 1. Follow the on-screen instructions to safely disconnect the camcorder from your computer. After connecting the camcorder to your computer, a removable disk will appear in your computer. The removable disk actually represents the storage medium of your camcorder. In the disk you can find all of your recordings. Refer to the figure below to see where the files are stored. When using the camcorder: Problem Cause The battery is out of power. If the camcorder stays idle over one minute, the LCD screen will automatically shut down to save power. [. . . ] If you have any other camcorder or capture device installed in your computer, please completely remove the camcorder and its driver from the computer to avoid the conflict. The device is not compatible with the camcorder. If you insert a SD card and the card is set to "Protected", this message will show up when the camcorder tries to write data into the card. When the camcorder is set to Playback mode without any existing file to play, this message will show up. [. . . ]