User manual AIPTEK HYPERPEN 12000U

[. . . ] These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. [. . . ] To remove the memory card, gently push the card and it will pop up. Turning on/off your camcorder Open the LCD monitor or press and hold down the Power button for 1 second to turn on the camcorder. To turn off the camcorder, press and hold down the Power button for 1 ~ 3 seconds or close the LCD monitor. If the camcorder stays inactive for a long period of time, it may automatically shut down due to the Auto-Off setting. Press the MODE key to enter the MODE menu. Use the Joystick switch to select the Setting mode and press OK to enter the menu screen. Use the Joystick to select the Language item, and then Press OK to confirm. Mode icon Video resolution Picture resolution Macro mode Battery life Zoom ratio indicator SD card inserted Remaining recordable time Note: Please make sure your memory card is inserted before recording. Zooming: Move the Zoom button up or down to zoom in or zoom out the screen. It's normal that the camcorder will feel slightly warm with continuous use / recording due to its high performance. Press the MODE key to enter the MODE menu. If the dialogue window does not appear automatically, you may double click on "My computer" and open the "Removable Drive". Copy the files you wish to keep and save them to the desired location on your computer. Please follow the below instructions to connect your camcorder and TV via accessory AV cables for real-time display. You can display your video clips and still pictures on your TV, sharing them with your friends and family. HD TV hereby means the HDTV built-in component input ports, thus can perform HD high resolution quality while connected. Plug one end of the component video cable into the (Component Video IN) port on the HDTV and the other end into the (HD OUT) port on Camcorder. Plug one end of the other AV cable into the (Component Audio IN) port on the HDTV and the other end into the (AV OUT) port on Camcorder. (Please do not plug in the yellow connector to HDTV's AV-IN. If you record an HD resolution clip while connected to your HD TV, the TV display video resolution will down size to D1 (480P) resolution due to data bit rate, but the recorded file will remain HD with no change. Power on your TV and switch the TV to AV mode. Connect the other end of the AV cable to the "AV out" port on your camcorder. [. . . ] Disable beep sound, but keep Shutter sound. A positive value makes the LCD brighter; while a negative value makes the LCD dimmer. Lets you select the language used for OSD. Icon Full battery life Moderate battery life Low battery life * The flash strobe and the LED lights will be disabled. [. . . ]