User manual AIPTEK POCKETCAM CLASSIC

[. . . ] The LCD display is combined with SW2 to show the setting information. Installing Batteries The Digital Camera is powered by 2 AAA batteries, or via the USB connector when attached to a PC. ***Notes *** When the batteries are unloaded, all of your stored pictures will be lost. (Battery Capacity: continous snapshot for 2 hours, stand by can work for approximately 2 week) Shutter Switch(SW1) View Finder Mode Switch(SW2) Battery Cover LCD Display USB Port Lens Battery Cover Switch . . 3 . . 20 English Switching the camera on Pressing the SW2 when the LCD is blank will power on the camera. The camera will automatically power off after 30 seconds of inactivity. The LCD indicates the camera mode either "Lr" for low resolution (QVGA images) or "Hr" for high resolution(VGA images). [. . . ] You may need to replace "D" with the letter that corresponds to your CD-ROM drive. Now your computer is initializing the Wise Installation Wizard. Please wait. Digital Camera Manager The welcome screen will appear, then click "Next"? The CD will begin installing the driver to the proper location. The dialog box that appears asks if you would like to restart your computer now or later. Press "OK" to complete installation. . . 7 . . English Start Digital Camera Manager Stored pictures may be uploaded to a PC at any time whether or not the camera is full. Plugging the USB connector into the camera will cause it to reset. A double beep will sound, but all stored pictures will remain. When the USB connector is unplugged the camera will switch off. When connected to the PC the camera may be used as a normal PC camera. Connect the smaller end of the USB connector to the side of the camera. Plug the other end of the USB connector into an available USB port on your computer. Note:When plugged into a USB port the camera gets its power from the PC. The camera may be used like this without any batteries. However, all pictures will be lost when the USB connector is unplugged. To start using the Digital Camera Manager, simply click on the "Start" menu and go up to "Programs" Then go to the folder named "Digital Camera" and select it. This is the program where you can begin to use your camera. . . 8 . . Mode Selecting = Press the "Live View" button to switch the camera to PC Camera mode. = Press the "DSC Function" button to switch the camera to DSC & Camcorder mode. Live View (PC Camera Mode) DSC Function (DSC Mode) PC Camera Mode In this mode, it is easy to attach the camera to your system, to use as a stand PC camera. the current view is displayed in the "preview" window. = Press "Video Source" button to adjust advanced setings. = Press "Video Format" button to set image size. = Press "Snap Shot" button to capture an image to album folder. = Press "Record button" to recording a video clip to album folder. . . 9 . . English DSC Mode Uploading Photos: This allows you to upload photos captured by the camera. < Press the "Link" button to link up the camera and upload photo icons. = Press the "Folder" button to open the album folder window. [. . . ] USB ports not enabled in the BIOS - Even after following the Quick Install Guide completely, the camera still does not work. Go into the Device Manager and see if a section called "Imaging Devices" is listed. If this section does not exist, check the "Sound, Video, and Game Controllers" section to see if the camera is listed there. If it is, then the problem is that the USB ports are not enabled in your BIOS. [. . . ]