User manual AIR LIVE WT-2000ARM

[. . . ] WT-2000ARM Turbo-G Wireless ADSL 2/2+ Router User's Manual Copyright and Disclaimer Copyright & Disclaimer No part of this publication may be reproduced in any form or by any means, whether electronic, mechanical, photocopying, or recording without the written consent of OvisLink Corp. OvisLink Corp. has made the best effort to ensure the accuracy of the information in this user's guide. However, we are not liable for the inaccuracies or errors in this guide. All information is subject to change without notice All Trademarks are properties of their respective holders. AirLive WT-2000ARM User's Manual Table of Contents Table of Contents 1. [. . . ] The interval of time that this wireless router broadcast a beacon. Beacon is used to synchronize the wireless network. The range for the beacon period is between 20 and 1000 with a typical value of 100 (milliseconds). When the packet size is smaller than the RTS threshold, the wireless router will not use the RTS/CTS mechanism to send this packet. Fragment Threshold specifies the maximum size of packet during the fragmentation of data to be transmitted. If you set this value too low, it will result in bad performance. Determines the interval the Access Point will send its broadcast traffic. The range is from 1~255, the default value is 3 beacons. 802. 11 b ­ This router will only work in 802. 11b mode. If there are only 802. 11b wireless clients in the network, you can set the router to this mode. Channel ID Beacon Interval RTS/CTS Threshold Fragmentation Threshold DTIM 802. 11b/g 802. 11 g ­ This router will only work in 802. 11g mode. If there are only 802. 11g wireless clients in the network, you can set the router to this mode. 802. 11 b+g ­ This router will support 802. 11b and 802. 11g communications simultaneously. It is recommended to set this mode. AirLive WT-2000ARM User's Manual 32 4. Quick Start SSID Parameter SSID Description The SSID (up to 32 printable ASCII characters) is the unique name identified in a WLAN. The ID prevents the unintentional merging of two co-located WLANs. The default SSID of the router is "airlive". Select "Yes" to make the SSID to be visible so wireless clients can scan the router within the network. Select "No" if you want to hide the SSID of the router. Wireless clients have to set the same SSID of the router in order to access the network. To prevent unauthorized wireless clients from accessing the router, this router supports WEP, WPA-PSK and WPA2-PSK authentication type. If the router has enabled the authentication, all the wireless clients' settings have to be consistent with the router for building the connection. Broadcast SSID Authentication Type WEP-64Bits Parameter Description WEP is less level of security than WPA. WEP supports 64-bit and 128-bit key lengths to encrypt the wireless data. [. . . ] The document series, begun in 1969, which describes the Internet suite of protocols and related experiments. Not all RFCs describe Internet standards, but all Internet standards are written up as RFCs. RFC 1483 Multi-protocol encapsulation over AAL-5. Two encapsulation methods for carrying network interconnect traffic over ATM AAL-5. The first method allows multiplexing of multiple protocols over a single ATM virtual circuit. [. . . ]