User manual AIRIS M137OK

[. . . ] They also serve to insert the page numbers in the Teletext mode. Remote Control Device Descriptoin (cont. ) To insert a one-digit number use the numerical keys from 0 to 9. To insert a two-digit number (10-99) first press any button from 0-9 to insert the first digit and then the second digit in less than 2 seconds, using the buttons from 0-9. Volume Control Keys (+/-): press the + key to raise the volume and the ­ key to lower it. Channel keys (+/-): press the + key to go to the next tuned-in channel. [. . . ] It will then disappear and be shown again when one minute remains before it is turned off. To deactivate it, press the button until the word OFF appears on the screen. REVEAL Button: press this button to show the current channel number, system data, etc. VIEW Button: press this button to return to the programme being watched previously 9. Source Select Button: use this button to select the external video sources that are connected to the screen. Every time the button is pressed, changes it to the new input source, in the following order: PC DVI TV AV S-VIDEO YcbCr SCART HDTV __________________________________________________| 10. MUTE Button: press this button to lower the volume temporarily. MONO/STEREO Button: when a channel is being received in stereo, this button can be used to select from among the different audio modes (stereo, mono, Dual A, DualB, Nicam, etc. ) available during transmission. PIP Button: press this button to superpose a window with another image source (not another TV channel) on the main image. When selecting the VGA or DVI input, this function will only be available if the VGA signal is set to 1024x768/60 Hz and the video source is set to full screen. SOUND Button: press this button to select the different sound effects: Personal/Cinema/Music and Dialogue. 14. Channel SWAP: when tuning in the channels, these are stored sequentially as they are found by the tuner. This option enables you to exchange the positions in which they were stored, so that they can be set according to your preferences. Programme label: this option enables you to name the programmes so that you can find the channel being tuned in at any time. When doing this, the programme number will be shown followed by the name input (TVE1, ANT3, TELE5, etc. . . ). When selected a key will appear on the screen. Use the direction keys to select the desired numbers or letters and then press the MENU key to select each one. When this operation has been completed, highlight the END, FINISH or FIN options to store the programme label. Select the option Channel Search and press the RIGHT enter the channel tuning sub-menu: FIGURE 2 direction key to The menu has the following options: Search Mode: Tune in or Surf. Select the SURF option if the TV system is NTSC. Aerial Type: this enables you to choose between cable or Air. Select AIR to tune in the channels available in Spain. [. . . ] Select the Automatic Search option and press the RIGHT direction key . The screen will start searching for the available channels and the following progress bar will be shown: FIGURE 3 This process takes a few minutes. After processing, it is returned to the main menu. If this is not the case and the screen shows the TV image, press the MENU key until figure 1 appears. [. . . ]