User manual AIRLIVE OV-1200SLC-20

[. . . ] OV-1200SLC/20 1000Base-SX/LX to 1000Base-SX/LX Fast Ethernet Media Converter User's Manual FCC Class B Certification This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] 1 SELECTING A SITE FOR THE EQUIPMENT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 CONNECTING TO POWER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 INSTALLING IN A CHASSIS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 LED INDICATOR. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 i AirLive OV-1200SLC/20 User's Manual Introduction Thank you for choosing the 1000Base Gigabit Ethernet Media Converter, The Converter introduced here provides one channel media conversion between 1000BASE-SX/LX . About Media Converter The Media Converter is a network technology specified by IEEE 802. 3 10BASE-T, IEEE802. 3u 100BASE-TX, 100BASE-FX standards. Product Features One-channel media conversion between 1000BASE-SX/LX and 1000BASE-SX/LX. Fiber media allows: multi-mode fiber and single-mode fiber using SC connector Full wire-speed forwarding rate Front panel status LEDs Used as a stand-alone device or with a chassis Hot-swappable when used with a chassis Installation This chapter gives step-by-step installation instructions for the Converter. Selecting a Site for the Equipment As with any electric device, you should place the equipment where it will not be subjected to extreme temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements: 1. The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius). The relative humidity should be less than 90 percent, non-condensing. Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength. Make sure that the equipment receives adequate ventilation. [. . . ] Step 2- Plug in the media board to any of the vacant slot. Step 3- Fit the converter onto the carrier and use the screw to secure it. 2 AirLive OV-1200SLC/20 User's Manual LED Indicator The LED indicators give you instant feedback on status of the converter: LEDs State Indication Power on Power off Linking on port FX-1 Not Linking Linking on port FX-2 Not Linking Power Steady (PWR) Lights off LINK-1 LINK-2 Lights on Lights off Lights on Lights off Specifications Standards: Data Transfer Rate: Duplex Mode: LED indicators: Media Interface: EMI Compatiblity: Temperture: Humidity: Power Consumption: IEEE802. 3z 1000BASE-SX/LX 1488000pps for 1000Mbps Full Duplex Mode PWR, LINK-1, LINK-2 SC FCC Class B CE Certification, Class B VCCI Class B Storage: -10°C ~ 70°C Operating: 0°C ~ 40°C 10% ~90% non-condensing 7. 2 Watts (maximum) 3 AirLive OV-1200SLC/20 User's Manual [. . . ]