User manual AIRLIVE SNMP-FSH2602MG V2

[. . . ] SNMP-FSH2602MG v2 24 + 2-port Mixed Gigabit SNMP Managed Switch User's Manual Copyright and Disclaimer Copyright & Disclaimer No part of this publication may be reproduced in any form or by any means, whether electronic, mechanical, photocopying, or recording without the written consent of OvisLink Corp. has made the best effort to ensure the accuracy of the information in this user's guide. However, we are not liable for the inaccuracies or errors in this guide. All information is subject to change without notice All Trademarks are properties of their respective holders. AirLive SNMP-FSH2602MG v2 User's Manual Table of Contents Table of Contents 1. [. . . ] Before configuring the stacking function, make sure all stack switches are in the same network. When configure stacking function, please must configure the master switch first. After stacking group has set up, all slave switches are configured through master switch. You still can directly access to slave switch, but all functions are read and view only. To remove the switch from stacking group, you must remove the salve switch first. When all slave switches are removed, and then you can remove the master switch from stacking group. If you remove the master switch before slave switch, go to slave switches one by one and use console configuration to re-configure the switch 56 AirLive SNMP-FSH2602MG v2 User's Manual 4. Web Management in SNMP-FSH2602MG v2 configuration or you re-configure one of the slave switched as the master by console interface. Click "IP Stacking" in the menu bar. Group ID (0. . . 65535): Assign a group ID for stacking group. The switches in the same stacking group have same group ID. Stacking Mode: Select the stacking mode from drag down list. Disable: It means the switch doesn't belong to any stacking group or stacking function is disabled. Master: It means the switch is the leader (master) in the stacking group. The master switch can control all the slave switches in stacking group. Slave: it means the switch is a slave switch of the stacking group. To configure the slave switch that you must access by the master switch. System Information: Enter system information in box. 57 AirLive SNMP-FSH2602MG v2 User's Manual 5. Console Management in SNMP-FSH2602MG v2 5 5. Console Management in SNMP-FSH2602MG v2 In this chapter, we will explain features that are available through console. For detailed descriptions on the concept and application of the settings, please refer to chapter 4. 5. 1 Connecting to the Console Port The Console port is a female DB-9 connector that enables a connection to a PC or terminal for monitoring and configuring the Switch. Use the supplied RS-232 cable with a male DB-9 connector to connect a terminal or PC to the Console port. 5. 2 Login in the Console Interface When the connection between Switch and PC is ready, turn on the PC and run a terminal emulation program or Hyper Terminal and configure its communication parameters to match the following default characteristics of the console port: AirLive SNMP-FSH2602MG v2 User's Manual 58 5. [. . . ] An IP address has two parts: an identifier of a particular network on the Internet and an identifier of the particular device (which can be a server or a workstation) within that network. The new IPv6 specification supports 128-bit IP address format. LACP (802. 3ad) Trunking Link Aggregation Control Protocol. It is protocol defines how to combine the several Ethernet ports into one high-bandwidth port to increase the transmission speed. Both devices must set the trunking feature to work. MAC 132 AirLive SNMP-FSH2602MG v2 User's Manual 10. [. . . ]