User manual AIRLIVE WL-1100SD

[. . . ] 3 SD WLAN Card Configuration Utility. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 configuring the utility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Status tab . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Statistics tab. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Wireless network infrastructures connected to an existing Ethernet network. About the SD WLAN Card CD-ROM The SD WLAN Card CD-ROM contains both software and documentation for the SD WLAN Card card. INSTALLING THE DRIVER Installation of the SD WLAN Card Driver to the Pocket PC using Microsoft Active Sync® 1. Connect your PDA to your computer and make sure Active-Sync® has established for a connection between the two devices. The following screen will apeear, click Install Driver to start driver installation. After driver installation is complete, clik Install Utility to start utility installation. Note: Do not insert the SD WLAN Card into the card slot of your PDA until the Driver (Step 1) and Utility (Step 2) installations have been performed. 2 Step 1 3. Click "YES" to proceed the installation. 4. Click "OK" to complete the driver installation. To verify if the installation of the driver was completed 3 successfully: 1. Soft reset the PDA (push Soft-reset Button of PDA) * Some PDA may not require resetting but it should be safer to reset. Insert the SD WLAN Card into the PDA Check the LED on the SD WLAN Card. If steady Blue light is seen, the SD WLAN Card is active. (Optional) To check the quality of the network connection, you should use the SD WLAN Card configuration utility program as described in the next section SD WLAN CARD CONFIGURATION UTILITY 1. Click Install Utility to perform utility installation. Step 2 2. Click "YES" to proceed the installation. 4 3. Click "OK" to complete the driver installation. CONFIGURING THE UTILITY Status tab SSID Status Type Channel Tx Rate The current access point name (ESS ID) The current connection status. The wireless radio channel currently used by the card. This can be 1 Mbps, 2 Mbps and 5. 5 Mbps. 5 IP MAC Signal Set AP Quality The IP address of the card. Shows the signal strength of the received signal. Click to enter wireless network configuration screen. Shows the signal quality of the received signal. Statistics tab Tx Success Tx Error Tx Throughput (kbps) Rx Success Rx CRC Error Rx Throughput (kbps) Reset The number of successfully transmitted packets. The number of unsuccessfully transmitted packets. The actual instantaneous transmit rates, in Kbps. The number of successfully received packets. The number of unsuccessfully received CRC packets. The actual instantaneous receive rates, in Kbps. Click to clear the previously settings. 6 Site Survey tab Rescan SSID BSSID Mode WEP CH Signal Support Rates Searches for all available networks. [. . . ] The most common cause is simple mistake. First check whether the card is inserted properly or not. Check whether any APs are available or not. If you see many APs, select any of one those APs and click connect. [. . . ]