User manual AIRLIVE WN-301USB

[. . . ] WN-301USB Wireless 11b/g/n 300Mbps USB Dongle User's Manual Copyright & Disclaimer No part of this publication may be reproduced in any form or by any means, whether electronic, mechanical, photocopying, or recording without the written consent of OvisLink Corp. OvisLink Corp. has made the best effort to ensure the accuracy of the information in this user's guide. However, we are not liable for the inaccuracies or errors in this guide. All information is subject to change without notice All Trademarks are properties of their respective holders. WN-301USB User's Manual 2 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. [. . . ] Click "Clear" to remove displayed information. 43 WN-301USB User's Manual 3. 6 Statistics This screen displays the transmit and receive statistical information of the AP. Click "Reset Counters" to clear the data. 3. 7 About This screen displays basic information about the utility, including the MAC address. WN-301USB User's Manual 44 4 Standards 4. Specifications · IEEE 802. 11b (1/2/5. 5/11Mbps Wireless LAN) · IEEE 802. 11g (6/9/12/24/36/48/54Mbps Wireless LAN) · IEEE 802. 11n (20MHz up to 72Mbps Wireless LAN) 11n (40MHz up to 150Mbps Tx/300Mbps Rx Wireless LAN) General · Interface: Hi-Speed USB 2. 0 · Chipset: Ralink · Frequency band: 2. 4000 ­ 2. 483 GHz (Industrial Scientific Medical Band) · Modulation technologies: - 802. 11b: Direct Sequence Spread Spectrum (DSSS): DBPSK, DQPSK, CCK - 802. 11g: Orthogonal Frequency Division Multiplexing (OFDM): BPSK, QPSK, 16QAM, 64QAM - 802. 11n: Orthogonal Frequency Division Multiplexing (OFDM): BPSK, QPSK, 16QAM, 64QAM · Security: - 64/128-bit WEP data encryption - WPA and WPA2 - 802. 1x - Cisco CCX · Transmit power: - 11n: 15 dBm +/- 1. 5 dBm - 11g: 15 dBm +/- 1. 5 dBm - 11b: 17 dBm +/- 1. 5 dBm · Receive Sensitivity: - 11n (40MHz): -61dbm - 11n (20MHz): -66dBm - 11g: -68dBm - 11b: -83dBm · Certification: FCC Class B, CE Mark LEDs · Link/Activity 45 WN-301USB User's Manual Environmental · Dimensions: 10 (H) x 19. 5 (W) x 56 (L) mm · Weight: 0. 14 kg · Operating temperature: 0 ~ 40°C (32 ~ 104°F) · Operating humidity: 10 ~ 90% RH, non-condensing · Storage temperature: -20 ~ 60°C (-4 ~ 14°F) WN-301USB User's Manual 46 5 table for possible solution. Frequent Asked Questions If you encounter any problem when you're using this wireless USB dongle, please check this FAQ I can't find any wireless access point / wireless device in "Site Survey" function. Answer: 1. Click "Rescan" and see if you can find any wireless access point or wireless device. Try to move closer to any known wireless access point. Please adjust the position of network card (you may have to move your computer if you're using a notebook computer) and click "Rescan" button for few more times. If you can find the wireless access point or wireless device you want to connect by doing this, try to move closer to the place where the wireless access point or wireless device is located. Question: Nothing happens when I click "Launch Config Utility" Answer: 1. Please make sure the wireless USB dongle is inserted into your computer's USB port. If the AirLive configuration utility's icon is not activated, the dongle is not detected by your computer. Remove the dongle and insert it into another USB port. Remove the driver/utility and then re-install it. 47 WN-301USB User's Manual Question: I can not establish connection with a certain wireless access point Answer: 1. Click "Connect" for few more times. If the SSID of access point you wish to connect is hidden (nothing displayed in SSID field in Site Survey function), you have to input the correct SSID of the access point you wish to connect. Please contact the administrator of the access point for SSID. You have to input the correct security key to connect an access point with encryption. Please contact the administrator of the access point for security password. The access point you wish to connect only allows network cards with specific MAC address to establish connection. Please go to the tab - About and write the value of Phy_Addess down, then present this value to the administrator of access point so he/she can add the MAC address of your network card to his / her access point's list. Question: The network is slow / having problem when transferring large files Answer: 1. Move closer to the place where access point is located. Disable Tx Burst under the tab - Advanced. Enable WMM under the tab - WMM if you need to use multimedia/telephony related applications. Uncheck Power Save Enable under the tab - WMM. Please try one or more solutions listed above. WN-301USB User's Manual 48 6 with caution. 6. [. . . ] In Dynamic Turbo, the channel binding will be used only if necessary. In Static Turbo, the channel binding is always on. This protocol may be combined with Super-A model to increase the performance even more. The used of channel binding might be prohibited in EU countries. TX Output Power Transmit Output Power. [. . . ]