User manual AIRLUX ATIF63BKM

[. . . ] Thank you for having chosen our induction ceramic hob. In order to make the best use of your appliance, we would advise you to read carefully the following notes and to keep them for a later consulting. The installation and connecting of the appliance have to be done by approved specialists. The manufacturer can not be responsible for damage caused by building-in or connecting errors. [. . . ] The symbol [ H ] disappears when the heating zones may be touched without danger. As far as the residual heat indicators are on light, don't touch the heating zones and don't put any heat sensitive object on them. If this function is activated the heating zones work during 10 minutes with an ultra high Power. This is foreseen for example to heat up rapidly big quantities of water, like nuddles Start up the Booster Stop the Booster Slide to the end of the "SLIDER" Or press directly on the end of the "SLIDER" Slide on the "SLIDER" Slide to the end of the "SLIDER" Or press directly on the end of the "SLIDER" Re-press key [ P ] Slide on the "SLIDER" Slide on the "SLIDER" The hole cooking hob is equipped with a maximum of Power. When the Power function is activated, and in order to exceed the maximum Booster, the electronic system orders to reduce automatically the power level of an other heating zone. The display is blinking on [ 9 ] during a few seconds and then shows the maximum of power allowed: The other heating zone: (example: Booster level 9) [ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone The timer is able to be used simultaneous with all heating zones and this with different time settings (from 0 to 999 minutes) for each heating zone. Select the power level Select theTimer Decrease the time Increase the time From the timer until the Press key [ - ] from the timer Press key [ + ] from the timer After a few seconds, the [ min ] display stops with blinking. The time is confirmed and the timer starts. Select the Timer Stop the time From the timer until the Press key [ - ] from the timer If several timers are activated, repeat the process. It stops as soon as a heating zone starts up. If the egg timer is on and the hob is switched off, the timer continues until time runs out. Action Activate the hob Select the Timer Decrease the time Increase the time Press key [ - ] from the timer Press key [ + ] from the timer After a few seconds, the [ min ] display stops with blinking. The time is confirmed and the timer starts. Automatic stop at the end of the cooking time: As soon as the selected cooking time is finished the timer displays blinking [ 000 ] and a sound rings. To stop the sound and the blinking, press the key [ - ] and [ + ]. All the cooking zones are equipped with an automatic cooking device. The cooking zone starts at full power during a certain time, and then reduces automatically its power on the pre-selected level. Start-up : Action Power level selection (for example « 7 ») Control panel slide on the "SLIDER" to [ 7 ] and stay 3s This function brakes all the hob's cooking activity temporarily and allows restarting with the same settings. Press pause key press pause key Press on the animated "slider" After switching off the hob [ 0/I ], it is possible to recall the last settings. Then press [ II ] before the light stops blinking. This function allows the reach and automatically maintains at the temperature of 42, 70 or 94°C. This will avoid liquids overflowing and fast burning at the bottom of the pan. [. . . ] On the other side, however, no unit or divider must stand higher than the hob. The piece of furniture or the support in which the hob is to be fitted, as well as the edges of furniture, the laminate coatings and the glue used to fix them, must be able to resist temperatures of up to 100 °C. The mural rods of edge must be heat-resisting. Not to install the hob to the top of a not ventilated oven or a dishwasher. [. . . ]