User manual AIRLUX AV685HWH

[. . . ] --In case of an intense or prolonged use of the equipment, it may be necessary to improve aeration, for Example by opening a window or increasing the mechanical suction power, if it exists. --The products of combustion must be discharged outside through a suction hood or an electric fan (see The product label, with the serial number, is sticked under the hob. The manufacturer refuses all responsibility for possible damages to things or people, resulting from a wrong installation or from an improper, incorrect or unreasonable use of this equipment. The symbols silk-screen printed on the side of the knob indicate the correspondence between the knob and the burner. [. . . ] When operating for the first time, it is necessary to eliminate any humidity or oil which may accumulated around the electric elements of the plate by operating the electric plate on its lowest setting (1) for about 30 minutes. To defrost frozen foods, cook stews, at to below boiling point. For foods which require boiling point, delicate meat and fish. Before any operation, disconnect the appliance from the electric grid. Don't use a steam cleaner for the cleaning the hob. It is advisable to clean the appliance when it is cold. Gas taps The possible lubrication of the taps must be carried out by specialized personnel, exclusively. In case of hardening or malfunctions in the gas taps, apply to the Customer Service. Glass platform and enamelled parts The glass platform and all of the enamelled parts must be washed with a sponge and soapy water or with a light detergent. do not use abrasive or corrosive products. Do not leave substances, such as lemon or tomato juice, salt water, vinegar, coffee and milk on the enamelled surfaces for a long time. Burners and racks These parts can be removed to make cleaning easier. The burners must be washed with a sponge and soapy water or with a light detergent, wiped well and placed in their housing perfectly. Make sure that the flame-dividing ducts are not clogged. Check that the feeler of the safety valve and the start-up electrode are always perfectly cleaned, so as to ensure an optimum operation. The racks can be washed in the dishwasher. Installing the top The appliance is designed to be embedded into heat-resistant pieces of furniture. The walls of the pieces of furniture must resist a temperature of 65°C besides the room one. The appliance is of type "Y", or it can be installed with one side wall to the right or left of the hob. The equipment must not be installed near inflammable materials, such as curtains, cloths, etc. Make a hole in the top of the piece of furniture, with the dimensions indicated in fig. 4, at a distance of at least 50 mm from the appliance border to the adjacent walls. [. . . ] As regards G30 gas burners, the by-pass screw must be tightened completely. If the power supply cable should be replaced, It is necessary to use a cable with a section of For the version mixed, type H05VV-F or H05RR-F, The connection to the terminal board must be This product complies with EU Directive 2002/96/EC. The crossed-out dustbin symbol reported on the appliance indicates that the appliance must be disposed of separately from other domestic refuse at the end of its useful life. It must therefore be delivered to a waste recycling centre specifically for electric and electronic equipment or returned to the retailer at the moment of purchase of a new equivalent appliance. [. . . ]