User manual AIRTRONICS SD-10G

[. . . ] If desired, you can create a shortcut to the Transfer Tool and run it from your Desktop. This software is compatible with Windows 32-bit and 64-bit operating systems. [. . . ] 8) Press the Close button and the New Hardware Found wizard will pop up again. Follow steps 6 and 7 to install the USB Serial Port driver. *Installation of the USB Serial Converter may be skipped if it was already installed on your PC by a previous program. USING THE TRANSFER TOOL General Overview 1) Plug the DIN connector into the back of the transmitter, then plug the USB connector into a free USB port on your PC. The green POWER light on the USB connector should illuminate. Continued on Back Page 2) Press and hold the transmitter DISPLAY key to turn the LCD Display ON. Only the LCD Display needs to be turned ON. The transmitter does not need to be turned ON. The USB Adapter Cable supplies power for transferring files or updating the firmware. 3) Double-click on the tx_tool. exe file to launch the Transfer Tool. 4) Click and highlight the COM port that the transmitter is connected to from the COM Port drop-down menu. The COM port will vary among different PCs, although generally it will be a COM port other than COM1. IMPORTANT In some cases, there may be more than two COM ports to choose from. To find out which COM port the transmitter is using, go to your Windows Device Manager and expand the Ports (COM & LPT) menu. USB Serial Port (COM X), where X is the COM port number the transmitter is using. See Windows Help for more information about Device Manager. Prior to initiating a Data Transfer, the transmitter DATA TRANSFER menu must be displayed. Prior to initiating a Software Update, the transmitter SYS. INFORMATION menu must be displayed. Transferring Programming Data For more information about how to choose the data transfer type and how to choose programming data for different models, see pages 55 and 56 of your SD-10G Operating Manual. [. . . ] 4) Press the ENTER key on your transmitter, then press the YES/+ key to start the firmware update. 5) Once the firmware update is complete, unplug the USB Adapter Cable and turn the transmitter OFF then back ON again to verify the new software version number. If you have any questions or require customer support, please contact us using the information below: Global Hobby Distributors 18480 Bandilier Circle Fountain Valley, CA 92708 Telephone: (714) 963-0329 Fax: (714) 964-6236 Email: service@airtronics. net Features and Specifications are Subject to Change Without Notice. [. . . ]