User manual AIWA AZ-BS1

[. . . ] 4-254-827-11(1) The player USB Memory Player with FM Radio Operating Instructions AZ-BS1/BS32 ©2004 Sony Corporation WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire, do not cover the ventilation of the apparatus with news papers, table cloths, curtains, etc. And don't place lighted candles on the apparatus. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. [. . . ] *2 Playback stops when all the tracks in the "pavit" have been played. To return to normal play mode Set the PLAY MODE switch to NORM. 14 B Listening to the radio PRESET TUNER Nx/POWER . (DOWN)/>(UP) Listening to the radio You can listen to FM broadcasts with and without inserting the "pavit" in the player. 3 1 Press and hold Nx/POWER until the player is turned on. If the radio was selected when you turned off the player last time, or if the "pavit" is not inserted in the player, the radio will be selected automatically when you turn on the player. Press TUNER repeatedly to select "FM 1" or "FM 2. " Press and hold . (DOWN) or > (UP) for about one second. The player starts scanning the frequencies and stops when it finds a receivable station. (DOWN) or > (UP) repeatedly, the frequency changes step by step. Using the radio 2 To turn off the radio Turn off the power by holding down Nx/ POWER until "SEE YOU" appears in the display. If you press Nx/POWER when the "pavit" is inserted in the player, music data will be played from the position where the playback was last stopped. When the "pavit" is not inserted in the player, radio reception will continue if you press Nx/POWER. (Continued) 15 To enhance detection of receivable stations If there are stations that you want preset but cannot do it automatically because their signals are not strong enough, change the setting of "AUTO STOP LEVEL" to "HIGH" in order to enhance detection of receivable stations. (DOWN) or > (UP) repeatedly to select "AUTO STOP LEVEL. " 3 Press MENU. (DOWN) or > (UP) to select "HIGH*. " In case the same station is preset on two or more preset numbers because its signal is too strong, set the "AUTO STOP LEVEL" to "LOW. " 5 Press MENU. * The default setting at the time of purchase is "MID. " To improve the reception The player's handle functions as the FM antenna. Change the position of the handle or the player itself to improve the reception. You can use the supplied FM wire antenna to gain extra sensitivity. Attach the FM wire antenna by screwing it into the EXT ANT socket on the rear side of the player as shown below. Then, extend and position the FM wire antenna for the best reception. Note Changing the setting of "AUTO STOP LEVEL" does not change the reception sensitivity. 16 Presetting radio stations You can preset up to 20 FM radio stations, 10 stations each for FM 1 and FM 2. To preset a station manually (Manual preset) If there is a station that cannot be preset automatically, you can preset it manually by the following procedure. Before starting, you must exit the auto preset mode (" " and the preset numbers should not be displayed). 1 Press TUNER repeatedly to select "FM 1" or "FM 2. " 2 Tune in the station you want to preset. 3 Press and hold PRESET for more than 2 seconds. " " and the preset numbers flash in the display. or > repeatedly to select the preset number you want to store the station on. The selected preset number starts flashing. 5 Within 10 seconds, press PRESET. To preset stations automatically (Auto preset) 1 2 3 Perform steps 1 and 2 of "Listening to the radio" (page 15) to select the band. " " and the preset numbers appear in the display. Press and hold PRESET for more than 2 seconds. [. . . ] Playback stops suddenly or the volume is reduced. Erroneous display. Additional information The upper part of the "pavit" insertion indicator " " flashes. 23 Battery Symptom Battery life is short. Cause/Remedy c The operating temperature is below 0°C (32°F). Battery life becomes shorter in cold temperatures due to battery characteristics. [. . . ]