User manual AIWA XR-MS3

[. . . ] 7 Condensation ­ Moisture may form on the CD pickup lens when: - The unit is moved from a cold spot to a warm spot - The heating system has just been turned on - The unit is used in a very humid room - The unit is cooled by an air conditioner When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again. 8 Wall or ceiling mounting ­ The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Total number of selected tracks Total playing time of the selected tracks A single track or all tracks can be played repeatedly. ""1" lights up when the single track repeat play is selected, and """ lights up when the all tracks repeat play is selected. 3 Repeat step 2 to program other tracks. Each time g is pressed in stop mode, a track number and program number will be displayed. To cancel repeat play, press REPEAT repeatedly while pressing SHIFT until """ and "1" disappear. To repeat random play First press RANDOM while pressing SHIFT to activate random play. Then press REPEAT while pressing SHIFT so that """ lights up. The track will be programmed after the last track. Clear the program and repeat all the steps again. nOTE · During programmed play, you cannot select the tracks directly with the numbered buttons or perform random play. In the following cases, the total playing time of programmed tracks is displayed as "--:--", which means you cannot check the total playing time of programmed tracks, but the programmed tracks are still registered in memory. - the total playing time of programmed tracks exceeds 99 minutes and 59 seconds. - you selected a track having a track number 31 or higher. When recording from a CD, CD play and tape recording start simultaneously. When recording from connected equipment, start play of the connected equipment. When recording from a CD, press s again to stop play. (Applicable when recording from a radio broadcast or connected equipment. 4-second blank spaces can be inserted at the desired point during recording. (Applicable when the source is a radio broadcast or connected equipment. ) 1 Press w REC/REC MUTE during recording or while in recording pause mode. 4 flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode. [. . . ] Do not leave the CD in places that are hot or humid. Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise. Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight. [. . . ]