User manual AKAI ATE-48N1104K

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference will not occur in a particular installation. If this equipment does cause by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. [. . . ] White: Press this button to show a full white picture. 25 Sleep: Press this button to select the sleep time. Insertion of Batteries: - Turn the remote control upside down, press and slide off the battery cover. - Insert two 1. 5V (AAA) batteries into the compartment, take care to observe the markings indicated inside. - Replace the cover and slide in reverse until the lock snaps. and 13 Range of Remote Control Sketch map 20 20 30 30 - Ensure the remote control is pointed towards the remote control window on the display unit. - No obstacles should be placed between the remote control and the remote control window. - The effective receiving range for the signal is within 5-8 meters from the front of the remote control window, and 30° to the left or right side and 20° above or below the control window. Care For Remote Control - Avoid spilling liquids on the remote. - Avoid dropping or otherwise jarring the remote. - Always store the remote control at dry and normal room temperature place. - If the remote is nor performing satisfactorily, replace the batteries. The batteries should be replaced after one year. - If the remote control will be idled for a long time (above 1 month) take out the batteries to avoid leakage from the batteries. HDMI don't support PC. DVI AUDIO HDMI red white DVD or Set-top box DVI DVD or Set-top box Connect audio amplifier or other TV set (Only for AV) 1. Connect audio amplifier apparatus or other TV set that with audio input. Connect the composite video output terminal to the video output terminal of the video input device. white red 16 Connecting the DVD, VCR or other video apparatus 1. With an S-VIDEO cable connect the PDP to the VCR or other device. S-VIDEO will connect only the video portion (image only) of the signal. With an AUDIO cable (RCA type) connect the AUDIO OUT from the device to the AUDIO IN on the PDP. With an AV cable connect to the Video plug of the PDP and the VCR or other video apparatus. With an AUDIO cable connect the audio output of the VIDEO of the VCR or other video apparatus to the audio input of the VIDEO of the PDP. Please ensure the Power Cord is connected and turn on Power Switch button before it is operated. Press STANDBY button to turn on the PDP. To watch the VCR or other video apparatus, please press SOURCE button to select S-VIDEO or AV. white red red white VCR etc. VCR etc. 17 6. [. . . ] Wring water out of the cloth before cleaning to prevent water from penetrating into the housing. Wipe the display with a dry cloth after cleaning. 4 Simple Troubleshooting: If the display fails or the performance changes dramatically, check the Display in accordance with the following instructions. Remember to check the peripherals to pinpoint the source of the failure. [. . . ]