User manual AKAI PDP4273M

[. . . ] OPERATING INSTRUCTIONS 42 Widescreen Plasma HDTV Monitor PDP4273M 1. Safety Guidelines Caution: Always use a power cable is properly grounded. Please use the AC cords listed below for each area: USA . . . . . . . . . . . . . . . . . . . . . CSA/cUL FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] - Clean up the entire remote control especially the battery compartment if any leakage found. - Do not mix using different kind of new and used batteries together to avoid leakage. 14 5. Connection to External Equipment Connecting the Computer 1. Connect the PDP to the computer with the D-Sub (VGA) cable. Connect the audio output of the computer to the audio input on the PDP. Please ensure the Power Cord is connected and turned on the STANDBY button before it is operated. Press STANDBY button on the remote control or on the PDP. The PDP and Computer are working at the same time. Press SOURCE button to select VGA on the remote control. D-Sub(VGA) PC Audio INPUT Connecting the DVD player or HDTV Set-top box using Component input 1. Connect the YPbPr output of the DVD player or HDTV Set-top box to the YPbPr input of the PDP. Connect the audio output of the DVD player or HDTV Set-top box to the audio input of the PDP. Please ensure the Power Cord is connected and turned on the STANDBY button before it is operated. Press STANDBY button on the remote control or on the PDP. Press SOURCE button again to select YPbPr 1 or YPbPr 2. green blue red white red green blue red white red DVD or Set-top box DVD or Set-top box 15 Connecting the DVD player or HDTV Set-top box using HDMI input 1. Connect the PDP to the DVD player or HDTV Set-top box with the HDMI cable. Connect the DVI AUDIO input terminal to the audio output terminal of HDTV Set-top box with DVI output terminal, and a DVI to HDMI conversion cable should be adopted. Please ensure the Power Cord is connected and turned on the STANDBY button before it is operated. Press STANDBY button on the remote control or on the PDP. The PDP and Computer are working at the same time. Press SOURCE button to select HDMI on the remote control. The second step is used, if you connect DVI output to the HDMI input of the PDP. The second step isn't used, if you connect HDMI output to the HDMI input of the PDP. [. . . ] If the Display still fails to perform as expected, contact the dealer for assistance. (Continued on next page) 34 The trouble status Power cannot be turned on. (Power indicator does not light) No Input Signal message appears. The way of shooting - Check that both ends of the power cable are plugged into the socket appropriately. - Check that the signal line is connected properly. - Check that the power of the relevant peripherals is turned on. [. . . ]