User manual AKAI QX4100

[. . . ] TABLE OF CONTENTS IMPROTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 PREPARATION FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 LOCATION OF CONTROLS AND INDICATORS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7 OPERATING INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] * Remove any descriptive labels that may be found on either the front or top cabinet of the unit. Do not remove any labels located on either the back or button cabinet of the unit. There is a white card in the CD compartment which is Intended to prevent the CD pickup from moving during shipment of the product. Remove this card from the CD compartment before use. Power Sources This audio system is designed to operate on 230V AC 50Hz house current . Attempting to operate this unit from any other power source may cause damage to unit, which is not covered by your warranty. AC Operation Unwind the AC cord and extend it to its full length, Insert the AC plug into any convenient 230V AC 50Hz household outlet . * Hold the plug to disconnect it from the mains outlet. * When the plug of the unit is connected to the mains outlet, the unit will be still connected to AC even of the power is turned off. * Disconnect the plug as soon as liquid or objects enter the unit. The unit cannot be used until being checked by experts. - GB- 3 - - GB- 4 - CONTROLS IDENTIFICATION 1. CD TRACK NUMBER DISPLAY FM STEREO LED INDICATOR REPEAT LED INDICATOR PLAY LED INDICATOR X-BASS LED INDICATOR MIX LED INDICATOR DIAL SCALE AND POINTER CD BUTTON TUNER BUTTON CD PLAY/PAUSE BUTTON CD STOP BUTTON MIX BUTTON MONO /STEREO SELECTOR BAND SWITCH (AM / FM) REPEAT BUTTON PROG. BUTTON CONTROL BUTTON COVER CD SKIP/FAST SEARCH BUTTON (FORWARD AND BACKWARD) X-BASS BUTTON PHONES JACK VOLUME / BUTTON POWER ON/OFF PROGRAM LED INDICATOR CD LED INDICATOR TUNER LED INDICATOR REMOTE SENSOR STANDBY LED INDICATOR TUNING KNOB CD DOOR EJECT BUTTON CD COMPARTMENT SPEAKER TERMINAL AC POWER CORD FM ANTENNA WIRE SPEAKER BOX SPEAKER WIRE - GB- 5 - - GB- 6 - REMOTE HANDSET 1. STAND BY : turn unit on/off (STANDBY mode) CD : turn CD mode on SKIP / SEARCH : skip the CD track or search within a track. VOLUME + / - : turn volume up / down PLAY : play or pause CD play STOP : stop CD play TUNER : turn tuner mode on and select waveband 1. 5. POWER SUPPLY This set operates at AC 230V - 50Hz 1. Insert the AC Power Cord(32) into a convenient standard outlet. Note: If the unit is switched off by pressing the STANDBY button on the remote control, it will be kept in the memory of standby. To turn on the unit: - by presing the STANDBY button on the remote control or - by pressing the POWER ON/OFF button (22) on the unit. Wait for about 5 seconds, press the same button again. The unit will be reset to tuner mode and the tuner LED indicator (25) will light on. LISTENING TO THE TUNER Press the POWER ON/OFF (22). Press the TUNER Button(9), the TUNER LED Indicator(25) will light up. [. . . ] Never allow your fingers to come in contact with the shiny, unprinted side of the disc. * Do not attach adhesive tape, stickers, etc. * Clean the disc periodically with a soft , lint-free, dry cloth. Never use detergents or abrasive cleaners to clean the disc. [. . . ]