User manual AKG AMM 10

[. . . ] Please read the manual before using the equipement!Do not expose the equipment to direct sunlight, excessive dust, moisture, rain, mechanical vibrations, or shock. Do not spill any liquids on the equipment or allow objects to fall inside through the ventilation slots. The equipment must only be used in dry rooms. [. . . ] Figure 10: Connecting the wires 4) Fasten the CAT cable to the adjacent retainer with a cable tie. The strain relief prevents the wires from being torn out of the terminal if the cable is pulled. Figure 11: Strain relief of the CAT cable 5) 6) 7) If the connected module is not the last module in the series, insert the further portion of CAT5 cable into the second terminal of the correct socket in the same way. The last module does not require any termination or similar device. Ballpoint pen) in the small pit in the middle of the orange lever to prevent slipping. Press on the orange part of the connector and the wire can be pulled out with a small amount of resistance. The AUX / LINE OUT module must be installed one slot away from the MASTER CONTROL, as the two modules are connected to one another via a separate cable. The connectors of this cable are mechanically coded and so cannot be connected the wrong way round. Use only the cable included with the REC module to connect this module. Connect the cable to the special connectors provided for that purpose (small white terminal strip). The LINE OUT (PASSIVE) module takes the electrically balanced output signal and uses it to drive power amplifiers, mixing desks or similar equipment. the volume and tone are controlled by the MASTER CONTROL. The level also depends on the setting of the input module that is used. The terminals of the LINE OUT module and the MASTER CONTROL module are coded so that the two channels, left and right, cannot be confused. connecting the power supply RISK OF INJURY!The PSU 10 power supply unit must be connected last. This module may only be installed by qualified technicians, observing relevant technical regulations and VDE directives. connection of the protective earth (PE) conductor is obligatory. The power supply connector is mechanically coded and can only be connected to the socket of the MASTER CONTROL. Because of the cable, the power supply unit must be mounted directly adjacent to the MASTER CONTROL. Figure 15: Connecting the power supply to MASTER CONTROL Installation and Connection Connecting TRAFO IN The TRAFO IN plug-in module can only be used in conjunction with the AUX/LINE IN module. Size 2 Allen key These screws fasten the black cover plate on the underside and the metal strain relief clip on the upper side. [. . . ] Never use caustic or scouring cleaners or cleaning agents containing alcohol or solvents, since these may damage the enamel and plastic parts. Type: Number Nominal level Overload resistance Type: Number Nominal level Minimum load impedance T. ± 12 V DC (± 10 %) ± 37 mA Phoenix screw terminal block Type: MC1. Type Nominal level Overload resistance Impedance Terminals Type Number Nominal level AMM 10 Electrically balanced -60 / ±0 dBu (switchable) 10 dB 15 k (@ 1 kHz) XLR 3-pole female Type Nominal level Overload resistance Impedance Phantom power Terminals Type Number Nominal level Minimum load impedance T. [. . . ]