User manual AKG BALANCE K 216 AFC

[. . . ] Use the equipment for the applications described in this manual only. AKG cannot accept any liability for damages resulting from improper handling or misuse. The AC adapter will draw a small amount of current even when the equipment is switched off. To save energy, disconnect the AC adapter from the power outlet if you will leave the equipment unused for a long period of time. [. . . ] Should any item be missing, please contact your AKG dealer. 1 Replacement Battery Packs, Separate Headphones The headphones will only operate with the supplied dedicated battery packs. To order more battery packs, please contact your AKG dealer. You can also order separate K 216 AFC headphones from your AKG dealer. 2 Replacement Ear Pads To mount the supplied, more solid replacement ear pads, refer to fig. Remove the ear pads (9) from the speaker capsules. Check that the AC mains voltage stated on the AC adapter is identical with the AC mains voltage in your area. Operating the AC adapter off a different AC mains voltage may damage the unit. Before connecting the transmitter to your audio source (TV set, radio, hi-fi system, etc. Connect the transmitter to your audio source using the supplied AK 2 connecting cable (white = left-hand channel, red = right-hand channel). Plug the AC adapter into a convenient power outlet. Before switching power to your system on, please note: · Using headphones at high volume levels, particularly for extended periods of time, may damage your hearing. ⷠOperating switches on your hi-fi system or connecting the transmitter to your audio source may cause clicks, which at high volume settings may affect your hearing. Therefore, be sure to set the volume control on the headphones to minimum (see fig. 5) before switching between different sources (tuner, turntable, CD player, etc. Interference caused by other users of the same frequency band is beyond AKG's control. Switch power to your audio source (and/or hi-fi system) on. If a battery pack is being charged inside the transmitter, the appropriate charging LED will remain lit red. Note: If no signal arrives at the transmitter input for five minutes, the transmitter will switch off automatically and the green transmitter status LED will go out. Before you can use the headphones, you will need to charge the battery pack inside the headphones. Insert the supplied replacement battery pack (3) into one of the charging slots in the transmitter side panels. You can leave the headphones on the transmitter and the battery packs inside the charging slots without risking to overcharge the batteries. [. . . ] the transmitter will switch off automatically approx. Five minutes after you switched off the audio source. Clogged ear pads may affect the sound quality. Allow the ear pads to dry completely and replace them on the speaker capsules. [. . . ]