User manual AKG C544

[. . . ] Please read the manual before using the equipment!Please make sure that the piece of equipment your microphone will be connected to fulfills the safety regulations in force in your country and is fitted with a ground lead. [. . . ] The supplied windscreen makes the microphone even less susceptible to wind and pop noise. A special moisture shield on the microphone capsule makes it difficult for moisture and makeup to penetrate into the microphone. This barrier prevents the microphone sound entries from being clogged by perspiration or makeup which would make the sound dull and reduce the sensitivity of the microphone. Therefore, never remove the moisture shield from the microphone!The C 544 is a condenser microphone and therefore needs a power supply. â· Using any power supply other than those recommended by AKG may damage your microphone and will void the warranty. Plug the mini XLR connector on the microphone cable all the way into one of the two mini XLR sockets on the B 29 L, the mini XLR socket on the connecting cable of the MPA V L, or the input jack on your bodypack transmitter. To disconnect the cable, press the unlocking button on the mini XLR connector (1) and pull the connector (1) out of the socket. MPA V L: Connect the MPA V L to a balanced XLR microphone input with phantom power and switch the phantom power on. Bend the gooseneck so that the microphone will sit to one side in front of the corner of your mouth. Should you hear excessive pop noise ("p" and "t" sounds are overemphasized unnaturally), move the microphone capsule further away from your mouth (up or back). â· If the microphone sounds "thin" or flat, move the microphone capsule closer to your mouth (refer to fig. [. . . ] Com For other products and distributors worldwide visit www. Specifications subject to change without notice. [. . . ]