User manual AKG CK 98

[. . . ] 2765Z0017): The GN 15 HT Installation Module allows you to connect any Discreet Acoustics Capsule Module to the HT 4000 handheld transmitter from AKG. ) gooseneck with mini jack plug, HCS mounting flange, and permanently connected DPA phantom power adapter with 3-pin XLR connector. ) cable, and DPA phantom power adapter, an ST 305 floor stand, and a 10-cm (4-in. B 18 battery power supply for all Installation Modules except GN 30 OC. [. . . ] Pull the circuit board out of the shell WITH EXTRA CARE. Position 1 7 Jumper in place Flat frequency response Mic on/off -> LED on/off No jumper Bass rolloff: -6 dB below 200 Hz LED off Positions 2 through 6 set the following functions: ON/OFF Key Functions Table 2a: ON/OFF Key Positions, 2, 3, 4: Be sure to place a jumper at one (but no more than one) of these three positions. If you place no jumper at any of these positions, pushing the ON/OFF button will have no effect. Positions 5, 6: Make sure there is a jumper placed at one of these positions at all times. With jumpers at both or none of these positions, the microphone status on power-up will be undefined. Never place two jumpers at positions 6 and 2 or 5 and 4 at the same time. this would effectively deactivate the ON/OFF button. Do not use any jumper configurations other than those given in Table 2a. Other configurations may cause malfunction. To make the circuit board slide more easily into the shell, turn the circuit board two or three times completely about its longitudinal axis as you push the circuit board in. Push the ON/OFF button into the opening in the shell to the point that the button clicks into place and tighten the fixing screw. If the phantom power on your mixing console is switchable, switch the phantom power on. You may also connect the GN 15, GN 30, and GN 50 installation modules to a PT 40, PT 400, or PT 4000 bodypack transmitter from AKG. The LED rings on the GN 30/50 Minijack Installation Modules will be powered from the phantom supply. ) To obtain an open channel indication, the installation technician may connect the LED ring to an external power source. In this mode, the LED ring will light much more brightly to draw the required attention to the open microphone. Unsolder the black wire (LED +) and the outer shield (LED -) from the HSC mounting flange and insulate the bare ends of the two wires. Solder to the two contacts on the HSC that are now unused a two-conductor cable for powering the LED ring. Use the supplied screws to fix the mounting flange in the hole. Use the supplied pipe clip to fix the phantom power adapter to the underside of the table. Use a shielded cable to connect the DPA phantom power adapter to a microphone input with phantom power. If the phantom power on your mixing console is switchable, switch the phantom power on. [. . . ] Stretch a suitable length of fishing line horizontally across the room, passing the fishing line through the eye on the HM 1000. Fix the fishing line to two opposite walls so as to create just enough downward pull to steady the microphone laterally. Screw the desired Capsule Module onto the GN 15 HT Installation Module CW. Screw the Installation Module onto the HT 4000 handheld transmitter CW. [. . . ]