User manual AKG CK93

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations. Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's authority to operate this equipment. [. . . ] When powering up for the first time, the first thing you need to do is select a Preset. read on in section "Automatic Frequency Selection. When powering up again later, the receiver will automatically come on in LOCK mode. The display will indicate the selected frequency in MHz for about 2 seconds, the battery type ("BATBAT" ­ two dry batteries, "-Accu-" ­ BP 4000) for about 2 seconds, and finally the frequency as a Preset Subchannel. The receiver is electronically locked so you cannot make any adjustments. You can scroll through the following status screens: - Preset (comes up only if a Preset has been saved): Carrier frequency shown as a Subchannel number within a Frequency Group. (This screen is only available if you are using a BP 4000 battery pack. ) In SETUP mode, the electronic lock is disabled so you can adjust all receiver parameters. To toggle between LOCK and SETUP modes, hold down the Jog switch for about 2 seconds. The "FREE" field lists the number of clean channels. If the receiver has found enough CHANNELs for your system, confirm the selected GROUP. This allows you to set the sound, compression, etc. Connect the stereo monitor outputs on your mixer to the two AUDIO IN jacks on the rear panel of the first transmitter. Connect the AUDIO LOOP jacks on the first transmitter to the AUDIO IN jacks on the next transmitter. Repeat step 2 for all other transmitters. 12): You can use one channel to distribute the same mono monitor mix to several SST 4s while feeding a personalized monitor signal for each musician to the other input channel on each SST 4500. This allows each musician to set their own balance between the two signals on the receiver. Explain to the musicians how to set the balance between the band mix and their own signals on the receiver. The "FREE" tag incidactes how many clean frequencies have been found. If this number is zero, you can raise the squelch threshold and try again. Remember, though, that a higher squelch threshold reduces the system range. ⷠClean frequencies are frequencies where the receiver finds no RF signal or an RF signal whose level is lower than the set threshold. [. . . ] "CH- 00" means the volume of both channels is the same. You can call up the balance screen even in LOCK mode by pressing the Jog switch briefly. You can set and save the balance between the left and right channels or channels 1 and 2. However, you cannot toggle between STEREO and DUAL modes. [. . . ]