User manual AKG CK98

[. . . ] Before connecting the equipment to power, check that the AC mains voltage stated on the supplied AC adapter is identical to the AC mains voltage available where you will use the equipment. Only operate the equipment with the supplied AC adapter with a 12-VDC output. Using adapters with a different output voltage or current type may cause serious damage to the unit. If any solid object or liquid should get into the equipment, shut down the system immediately. [. . . ] Use of two receivers in one rack 1) 2) Fit both receivers in the rack with one unit of space between them. Check that the AC mains voltage stated on the included power supply is identical to the AC mains voltage available where you will use your system. Using the power supply with a different AC voltage may wreck the unit. Plug the feeder cable of the included power supply into the 12 V, 0. Ensure that you are using the correct adapter for the country you are in. Use an XLR cable to connect the BALANCED output (10) of the required channel on the back of the receiver to the balanced microphone input (XLR socket) on the mixer or amplifier. Use an XLR cable to connect the sum output (9) of all four channels on the back of the receiver to an active speaker. This green button is illuminated when the receiver is ready for use. Unscrew thebattery cover (14) from the handheld transmitter. The transmitter will not function if you insert the batteries the wrong way round. Close the two battery compartment covers. Actions 3 and 4 can be started from the transmitter and receiver. In this example, they are started from the receiver. 1) 2) 3) Pull the battery compartment cover (14 / 22) down and off the transmitter. switch on the transmitter and receiver. Press Connect (3) on a free channel of the receiver and hold down until the status LED (5) starts to flash after approximately 2 seconds. You need to confirm with the transmitter within the next 30 seconds. Hold down Connect (16) on the transmitter until the status LED (13) lights up green. The status LEDs on the transmitter (13) and the receiver (5) light up green once assignment has been successful. This means that you can simply continue using the DNS 70 system with the last-used settings (channel assignments) the next time you switch on. Dual channel use is not possible with the CK98 system. Several transmitters can't be assigned to a single channel on the receiver. [. . . ] Clean the surface of the unit with a moistened (not wet) cloth. Never use caustic or scouring cleaners or cleaning agents containing alcohol or solvents, since these may damage the enamel and plastic parts. Take the windshield (foam insert) out of the wire-mesh cap. As soon as the windshield has dried, replace it in the wire-mesh cap and screw the wiremesh cap onto the handheld transmitter. [. . . ]