User manual AKG CS 2

[. . . ] Please read the manual before using the equipment!Zentrale CS 2 BU Netzgerät: CS PS 20 oder CS PS 100 Netzkabel: CS MK AC-EU, CS MK AC-US oder CS MK AC-UK Sprechstellen: CS 2 DU, CS 2 DU fix, CS 2 CU oder CS 2 CU fix Verbindungskabel: CS MK 1. Farbe Lieferumfang Bestellnummern CS 2 CU CS 2 DU CS 2 CU fix CS 2 DU fix Do not spill any liquids on the equipment and do not drop any objects through the ventilation slots in the equipment. The equipment may be used in dry rooms only. [. . . ] To prevent damage to the Base Unit, do not connect any remote devices to these pins. You can use a Y cable (not supplied) to connect an equalizer or feedback killer to the EFFECT insert jack on the rear panel of the Base Unit. Examples: External sound system to LINE OUTPUT; recording device to REC OUT; CD player to AUX IN; wireless microphone system (e. 1 through 8 conforming to your system design: In the "OFF" position, the gate threshold is high and the microphone will not come on unless the user talks into it from a very short distance. As soon as the microphone is open, the threshold will be automatically reduced by 6 dB so the microphone will not switch off if the talker speaks more softly or moves away from the microphone. In the "ON" position, the gate threshold is 6 dB lower than in the "OF" position. Again, as soon as the microphone is open, the threshold will be automatically reduced. 2 toggles the time the microphone remains open after the talker stops talking between 12 seconds ("OFF") and 6 seconds ("ON"). In the "OFF" position, the microphone will be muted automatically after the delay you set with dip switch no. In the "ON" position, the microphone will not switch off unless the delegate presses the PTT switch. 4 allows you to switch the Microphone Station out of the NOM Limitation bus, so this is an important option for Chair Stations. In the "OFF" position, the user can switch their microphone on at any time, no matter how many microphones are open already. In the "ON" position, the microphone can not be activated unless the number of open microphones is lower than the number set on the Base Unit. However, if the Base Unit operates in Voice Activation mode, the microphone will come on automatically when talked into. 6 allows you to switch the Microphone Station out of the priority mute bus. If you connect the maximum number of Microphone Stations, distribute the Microphone Stations to LINE 1 through 4 as recommended in Table 4 above. Also, make sure the total cable length from the Base Unit to the last Microphone Station does not exceed 330 feet (100 m). This is the only way to ensure that all Microphone Stations will receive an adequate supply voltage (21 VDC minimum). Select the proper gooseneck and microphone capsule for each Microphone Station. for details refer to the Discreet Acoustics Modular Series manual. You can also use each type of Microphone Station with no microphone, as a monitoring device, e. Screw the gooseneck into the microphone jack on the Microphone Station. [. . . ] Use external sound system instead of built-in loudspeakers. Use headphones instead of built-in loudspeakers. The system works but some Microphone Stations do not. Input level for <1% THD LINE INPUT Connector Nominal input level Type Input impedance at 1 kHz Max. [. . . ]