User manual AKG DPT 700 V2

[. . . ] The color code (3) protects the charging contacts from damage or dirt and your fingers from injury when opening or closing the battery compartment cover (7). Therefore, never remove the color code (3) except for charging the DHT 700 on the CU 700. Com For other products and distributors worldwide visit www. Please read the manual before using the equipment! [. . . ] To engage SILENT mode, push and hold the MUTE switch (2) while turning on (6) the transmitter. This is the only way to make sure you won't go "on air" on a frequency that is not allocated or coordinated and risk "jamming" or interfering with some other RF device or wireless system. The receiver is electronically locked so that you won't make any unintended adjustments. To enter SETUP mode, press and hold the SELECT control (5) until the "LOCK" label disappears. After approximately 4 minutes with no action, the receiver will automatically switch into LOCK mode. The optional RMS 4000 Remote Mute Switch allows muting of the transmitter if it is mounted in a Optional position where it is difficult or impossible to use the "on-board" MUTE switch. Short push: Confirms status and warning messages. CH1 / CH2 Buttons Depending on the current menu the channel keys have different functions. Quick Setup Menu: From the CHANNEL LIST, you can directly select and synchronize any open channel. The channel sub-menu lets you select a different channel. BACK Button (4) A short push will close the current menu and all unconfirmed values are erased. Holding the BACK key will close all menus, all unconfirmed values are erased and the general window is activated. DSP Button (2) The DSP button allows you to bypass the LOW CUT filter, EQ, COMPRESSOR, and LIMITER for each channel individually. To activate the audio output, push the headphones CH1 or CH2 button next to the headphones socket briefly. To deactivate the audio push the headphones CH1 or CH2 button for more than 1 second. â· You can adjust the headphone volume with the SELECT control directly after pushing the headphones section CH1 or CH2 button. The general window shows all necessary parameters for operation. In addition to a freely-selectable name, the current frequency, the current group and channel, you can check the audio level, the active antenna, and the remaining use time of the transmitter battery. The selected warning functions are active in LOCK and ACTIVE modes. â· To delete a warning message from the display, press the SELECT control briefly. A small warning message is displayed in the main window until the warning is confirmed. RF LOW: The field strength of the received RF signal is too low, the receiver's audio output is muted to prevent unwanted noise. [. . . ] This menu lets you change the display appearance. You can choose from four different displays: MAIN GROUP/CHANNEL DISPLAY MODE COUNTRY The DISPLAY CONTRAST sub-menu allows you to adjust the contrast of the display for use in vary- DISPLAY CONTRAST ing lighting conditions. The FACTORY RESET sub-menu allows you to reset all parameters to their default values. The INFO sub-menu lets you call up software information about your receiver and the transmitter syn- INFO chronized to it. [. . . ]