User manual AKG HEARO 888 TITAN

[. . . ] In order to make optimum use of the benefits of your HEARO 888 TITAN, please take a few minutes to read the instructions below carefully before operating the equipment. Please keep the manual for future reference. Uses digital signal transmission for minimum noise, wider dynamic range, better highfrequency reproduction, lower distortion, and better interference rejection. ⷠConnects to any audio, video, TV set, or PC with a headphones or line output; · Provides perfect sound reproduction, full mobility, and signal transmission through walls and ceilings over a distance of up to 165 feet (50 m); · The HEARO 888 TITAN system lets you share your listening enjoyment with other persons. [. . . ] Connect your wired headphones to the headphones jack on your amplifier. Refer to the operating manual of your amplifier for instructions on how to listen to and disable the signal at the TAPE" or "PLAYBACK" input. On most amplifiers, you can push the "TAPE MONITOR" switch IN to listen to the processed signal and OUT to cut the processed signal. In this mode, the loudspeakers will also reproduce the processed signal present at the Important: headphones output. Since IVA and/or surround processed signals are not loudspeaker compatible, mute the loudspeakers while listening through headphones. When listening over loudspeakers, cut the processed signal. In order to ensure the longest possible service life for the rechargeable batteries, we deliver 4. 1 Charging the Batteries them uncharged. Therefore, charge the supplied batteries before first operating in the Headphones your headphones system. The supplied batteries have been inserted into the headphones for your convenience. If you operate the headphones on dry batteries, never try to charge the WARNING: batteries using the transmitter's charging feature. This would cause serious damage to your headphone system. Dispose of spent batteries conforming to local waste disposal rules. When the power is off, the POWER LED (2) will be dark. The CHARGE LED (7) on the transmitter will light red to indicate that the batteries in the headphones are being charged. If signal is present at the transmitter audio input, the CHARGE LED (7) will light orange. You may leave the headphones on the transmitter for as long as you like without risking to overcharge the batteries. In order to maintain full battery capacity for as long as possible, discharge the batteries Important: completely about once a month: Switch the headphones on and leave them outside the transmitter until the POWER LED (2) extinguishes. 2 Replacing Batteries to recharge the supplied batteries more often than would be convenient, you may consider replacing the batteries with new AAA size 1. Remove the ear pad from the left-hand earphone as shown in fig. 10, insert the new batteries into the battery compartment (4). Make sure to align the batteries with the polarity marks inside the battery compartment. [. . . ] Batteries are not correctly aligned with polarity marks. Readjust TUNING control on headphones or use FREQ ADJUST control on transmitter to select different carrier frequency and readjust TUNING control on headphones. Audio level at transmitter input is too low. Audio level at transmitter input is too high. [. . . ]