User manual AKG IVM 4

[. . . ] Com For other products and distributors worldwide visit www. Please read the manual before using the equipment!Specifications subject to change without notice. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Parts 74 and 15 of the FCC Rules. [. . . ] You can scroll through the following status screens: - Preset (comes up only if a Preset has been saved): Carrier frequency shown as a Subchannel number within a Frequency Group. (This screen is only available if you are using a BP 4000 battery pack. ) In SETUP mode, the electronic lock is disabled so you can adjust all receiver parameters. (The room simulator will generate a stereo signal from any mono input signal. ) Connect the stereo monitor outputs on your mixer to the two AUDIO IN jacks on the transmitter rear panel. If your mixer can provide two different monitor signals (e. You can use these outputs as follows: A (refer to fig. 13): You can feed the same stereo monitor signal to one or more SST 4 transmitters. This allows you to set the sound, compression, etc. Connect the stereo monitor outputs on your mixer to the two AUDIO IN jacks on the rear panel of the first transmitter. Connect the AUDIO LOOP jacks on the first transmitter to the AUDIO IN jacks on the next transmitter. Repeat step 2 for all other transmitters. 14): You can use one channel to distribute the same mono monitor mix to several SST 4s while feeding a personalized monitor signal for each musician to the other input channel on each SST 4. This allows each musician to set their own balance between the two signals on the receiver. Explain to the musicians how to set the balance between the band mix and their own signals on the receiver. C ­ other applications: You can also feed the AUDIO LOOP signal to a separate amplifier for stage monitors, a headphone amplifier, or a recording device. Check that the AC mains voltage stated on the included power supply is identical to the AC mains voltage available where you will use your system. Using the power supply with a different AC voltage may cause damage to the unit. Plug the feeder cable on the included power supply into the DC ONLY socket on the transmitter rear panel and screw down the DC connector. Plug the power cable on the power supply into a convenient power outlet. Hold down the ON/OFF control for about 2 seconds. When powering up for the first time, the first thing you need to do is select the appropriate Preset for the country where you are going to use your IVM 4. [. . . ] You can call up the following details about your transmitter in this order: - Firmware version (e. To clean the transmitter and receiver surfaces, use a soft cloth moistened with water. Use a soft cloth moistened with water to clean the earbud surfaces. To prevent infections, clean the ear molds with a skin compatible antiseptic before and after use. [. . . ]