User manual AKG PERCEPTION 420

[. . . ] Please read the manual before using the equipment!This Manual contains important instructions for setting up and operating your equipment. Please take a few minutes to read the instructions below carefully before operating the equipment and keep the Manual for future reference. [. . . ] 2) further reduces low-end distortion caused by footfall or wind noise, etc. The filter also minimizes the proximity effect that close-in miking from less than 4 inches The filter rolls off at 12 dB/octave from 300 Hz downward. Neither the diaphragm nor the backplate are permanently polarized, so the Microphone needs an external power supply. 2 Pinout The microphone provides a balanced output on a 3pin male XLR connector: Pin 1: ground Pin 2: hot Pin 3: cold Use an XLR cable to connect the microphone to a balanced XLR input with phantom power. (Refer to the user manual of the unit to which you connected your microphone. Every instrument radiates its sound in a specific way. Therefore, to get the best sound it is crucial to experiment with microphone placement. Whichever polar pattern you selected, it may be good to know which way the transducer axis is facing: the front of the microphone is the side of the body with the AKG logo and polar pattern selector (1) on it. â· When recording wind instruments or vocals, make sure not to blow or sing directly into the microphone. To avoid unwanted wind and pop noise or moisture problems, place an optional PF 80 pop screen from AKG between the microphone and vocalist/instrument. Moisture from blowing or singing directly at the capsule from a short distance, or extremely high humidity may cause the microphone to start crackling or go very quiet due to partial short circuits in the polarization voltage. â· If you use the microphone in the open, use an optional AKG W 4000 windscreen to protect the microphone from moisture and reduce wind noise. â· High volume instruments: You can use this microphone for close-in recording of very loud instruments (brass instruments, kick drum, etc. Low-frequency noise: To suppress low-frequency noise such as air conditioning rumble, footfall noise, or traffic sounds, switch the bass cut filter in. 2 Selecting Polar Patterns Each of the PERCEPTION 420's selectable polar patterns is virtually frequency independent so that reflected sound, too will be reproduced accurately and uncolored. Remember to aim the microphone front (see fig. [. . . ] To order a free copy of the Declaration of Conformity, visit http://www. Com For other products and distributors worldwide visit www. Specifications subject to change without notice. [. . . ]