User manual AKG PERCEPTION WIRELESS

[. . . ] Please read the manual before using the equipement!Do not spill any liquids on the equipment. The equipment must only be used in dry rooms. The equipment must only be opened, serviced, and repaired by authorised personnel. [. . . ] Never use both outputs (BALANCED and UNBALANCED) at the same time. Reflections off metal parts, walls, ceilings, etc. or the shadow effects of musicians and other people may weaken or cancel the direct transmitter signal. For best results, set up the receiver as follows: 1) Place the receiver near the performance area (stage). Make sure, though, that the transmitter will never be any closer to the receiver than 10 ft (3 m). 2) Check that you can see the receiver from where you will be using the transmitter. 5 m) away from any large metal objects, walls, scaffolding, ceilings, etc. Use an XLR cable to connect the BALANCED output on the back of the receiver to a balanced microphone input (XLR socket) on the mixer or amplifier. To avoid hum interference, do not use audio cables that are longer than 10 feet (3 m). Check that the AC mains voltage stated on the included power supply is identical to the AC mains voltage available where you will use your system. Using the power supply with a different AC voltage may wreck the unit. Plug the feeder cable of the included power supply into the DC IN socket on the receiver. Plug the AC adapter into a power outlet. Pull the battery compartment cover off the transmitter in the direction shown by the arrow. insert the supplied battery into the battery compartment conforming to the polarity marks. The transmitter will not function if you insert the battery the wrong way round. Replace the battery with a new one as soon as possible. If you use a rechargeable battery, the LED will change to red approximately 15 minutes before the battery goes flat. To close the battery compartment, slide the battery compartment cover onto the battery compartment from below until the snap hook engages. 1) blinks for 3 seconds after which it is displayed without blinking, indicating that the selected channel is active. During those 3 seconds, press CHANNEL to obtain the required channel number. Each press of the button increases the channel number by one. [. . . ] It gives more "body" to your voice and an intimate, bass-heavy sound. Angle of incidence Sing to one side of the microphone or above and across the top of the microphone. this provides a well-balanced , natural sound. If you sing directly into the microphone, it will not only pick up excessive breath noise but also overemphasise "s", "sh", "tch", "p", and "t" sounds. [. . . ]