User manual AKG PS 4000

[. . . ] Please read the manual before using the equipment!FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Parts 74, 15, and 90 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] All antennas are wideband devices for the entire WMS 4000 UHF band. the active antennas are powered by the PS 4000 antenna splitter via the antenna cables. For complex systems with long antenna cables, we recommend powering each active antenna from a PSU 4000 central power supply via an ASU 4000 remote power adapter. the SRA1 is a remote UHF antenna with a hypercardioid polar pattern. The SRA1 will even operate perfectly as close to the floor or ceiling as 15 cm (6 in. The SRA 2 B is an active directional antenna with a rugged, water-resistant case designed specifically for indoor and outdoor use at a distance from the performance area. Using RG213 antenna cables and two AB 4000 antenna boosters in series, you can set up the SRA 2 B even 200 m (660 ft. An optional laser pointer makes it easy to align the antenna precisely with the performance area. The RA 4000 B is an active omnidirectional antenna with a rugged, water-resistant case designed specifically for indoor and outdoor use in close proximity to the performance area. Using RG213 antenna cables and two AB 4000 antenna boosters in series, you can set up the SRA 2 B even 200 m (660 ft. Unscrew the four rubber feet (1) from the antenna splitter bottom panel. Unscrew the two fixing screws (2) from each side panel. Use the fixing screws (2) to screw the short bracket (3) to one side panel and the long bracket (4) to the other side panel. Unscrew the four rubber feet (1) from each antenna splitter's bottom panel and remove the screws (5) from the rubber feet (1). Unscrew the two fixing screws (2) from the right-hand side panel of one antenna splitter and from the left-hand side panel of the other antenna splitter. Remove the plastic covers (3) from the side panels with the fixing screws (2) still on. Insert one connecting strip (4) into each free slot in the side panel of the first antenna splitter, making sure to align the hole in each connecting strip (4) with the appropriate threaded hole in the antenna splitter bottom panel. Fix the two connecting strips (4) on the first antenna splitter using two of the screws (5) you removed from the rubber feet. To join the two antenna splitters, slide the connecting strips (4) on the first antenna splitter through the free slots in the side panel of the second antenna splitter. Make sure to align the hole in each connecting strip (4) with the appropriate threaded hole in the bottom panel of the second antenna splitter. Fix the two connecting strips (4) on the second antenna splitter using two of the screws (5) you removed from the rubber feet. Screw a short bracket (6) to the outer side panel of each antenna splitter using for each bracket two of the screws (2) you removed from the antenna splitter side panels. [. . . ] Press the ON/OFF key on the antenna splitter to switch power to the antenna splitter ON. The blue OK LEDs and the green status LEDs on the connected active components will illuminate. Press the ON/OFF key on the antenna splitter to switch power to the antenna splitter OFF. The blue OK LEDs and the green status LEDs on the connected active components will extinguish. [. . . ]