User manual AKG PT 40 FLEXX

[. . . ] Should any of these items be missing, please contact your AKG dealer. You can use the PT 40 PRO bodypack transmitter with both dynamic microphones and condenser microphones operating on a supply voltage of approx. MUTE: The signal delivered by the microphone element is muted while power and the RF carrier frequency remain on. LED lit red: From the moment the LED changes to red, the battery capacity will provide a maximum of two operating hours. [. . . ] The transmitter will not function if you insert the battery the other way round. If the status LED (3 is lit red, the battery will be dead within about two hours. Replace the battery with a new one as soon as possible. â· If you use a rechargeable battery, the LED will switch to red 15 minutes before the battery will be dead!To close the battery compartment, slide the battery compartment lid (1) onto the battery compartment from below to the point that the snap hook will engage. A) Plug the mini XLR connector on the cable of your microphone into the audio input socket (2) on the bodypack transmitter. B) Plug the jack plug on the MKG L guitar cable into the output jack on your instrument and the mini XLR connector on the guitar cable into the audio input socket (2) on the bodypack transmitter. Use the screwdriver (1a) integrated in the battery compartment lid (1) to set the GAIN control (4) to a position where the AF CLIP LED on the receiver will flash occasionally. If the transmitter and receiver are tuned to different frequencies, no signal will be received!A) Plug the mini XLR connector on the cable of your microphone into the audio input socket (2) on the bodypack transmitter. B) Plug the jack plug on the MKG L guitar cable into the output jack on your instrument and the mini XLR connector on the guitar cable into the audio input socket (2) on the bodypack transmitter. Use the screwdriver (1a) integrated in the battery compartment lid (1) to set the GAIN control (4) to a position where the AF CLIP LED on the receiver will flash occasionally. Move the transmitter around the area where you will use the system to check the area for "dead spots", i. , places where the field strength seems to drop and reception deteriorates. If you find any dead spots, try to eliminate them by repositioning the receiver. If this does not help, avoid the dead spots. The RF OK LED on the receiver going out means no signal is being received or the squelch is active. Switch the transmitter on, move closer to the receiver, or set the squelch threshold to the point that the green RF OK LED will be lit. [. . . ] Switch off interference sources or defective appliances, use a WMS 40 SINGLE/DUAL tuned to a different frequency, or switch WMS 40 FLEXX to different frequency; have electrical installation checked. Turn GAIN control down or up just enough to stop the distortion. Switch off interference sources or defective appliances, use a WMS 40 SINGLE/DUAL tuned to a different frequency, or switch WMS 40 FLEXX to different frequency; have electrical installation checked. GAIN control is set too high or too low. [. . . ]