User manual AKG SR 40 DIVERSITY

[. . . ] Do not spill any liquids on the equipment and do not drop any objects through the ventilation slots in the equipment. The equipment may be used in dry rooms only. The equipment may be opened, serviced, and repaired by authorized personnel only. Before connecting the equipment to power, check that the AC mains voltage stated on the supplied AC adapter is identical to the AC mains voltage available where you will use the equipment. [. . . ] If none of the LEDs illuminates, the gain setting on the transmitter is too low. the PEAK LED lighting constantly indicates overmodulation. VOLUME: This rotary control adjusts the receiver's output level from microphone to line level for matching to the input sensitivity of your mixer or amplifier. Prior to setting up your WMS 40, check that the transmitter and receiver are tuned to the same frequency. The easiest way to do this is to compare the color codes on the transmitter and receiver. Reflections off metal parts, walls, ceilings, etc. Place the receiver near the performance area (stage). Make sure, though, that the transmitter will never get any closer to the receiver than 10 ft (3 m). Check that you can see the receiver from where you will be using the transmitter. You can either use the receiver freestanding or mount it in a 19" rack using the optional RMU 40/div. Unscrew the four rubber feet from the receiver bottom panel. Unscrew the two fixing screws from each side panel. Use the fixing screws to screw the short bracket to one side panel and the long bracket to the other side panel. To mount two receivers side by side in the same rack slot, you will need two optional RMU 40/div. Unscrew the four rubber feet from each receiver's bottom panel and remove the screws from the rubber feet . Unscrew the two fixing screws from the right-hand side panel of one receiver and from the left-hand side panel of the other receiver. Remove the plastic covers from the side panels with the fixing screws still on. Insert one connecting strip into each free slot in the side panel of the first receiver, making sure to align the hole in each connecting strip with the appropriate threaded hole in the receiver bottom panel. Fix the two connecting strips on the first receiver using two of the screws you removed from the rubber feet. To join the two receivers, slide the connecting strips on the first receiver through the free slots in the side panel of the second receiver. Make sure to align the hole in each connecting strip with the appropriate threaded hole in the bottom panel of the second receiver. Fix the two connecting strips on the second receiver using two of the screws you removed from the rubber feet. [. . . ] Move receiver away from or metal objects. Switch off interference wireless systems, TV, radio, sources or defective appliCB radios, or defective ances or use a WMS 40 electrical appliances or tuned to a different freinstallations. Turn GAIN control down or is set too high or too low. Switch off interference CB radios, or defective sources or defective applielectrical appliances or ances or use a WMS 40 installations. [. . . ]