User manual AKG SR 40

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations. Changes or modifications not expressly approved in writing by AKG Acoustics may void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. [. . . ] VOLUME: This rotary control adjusts the SR 40's output level from microphone to line level for matching to the input sensitivity of your mixer or amplifier. RF: This LED lights to indicate that signal is being received. If no signal is received or the squelch is on, the RF LED goes out and the audio output is muted. color Code: The color indicates the carrier frequency of your receiver. Transmitters tuned to the same frequency are marked with identical colors. 375 MHz MHz MHz MHz MHz MHz MHz MHz MHz MHz reddish brown purple mint green dark gray Bordeaux red yellow violet green melon yellow gray Received signal is too weak, in order to suppress the related noise or the residual noise of the receiver while the transmitter is off. Prior to setting up your WMS 40, check that the transmitter and receiver are tuned to the same frequency. The easiest way to do this is to compare the color codes on the transmitter and receiver. Reflections off metal parts, walls, ceilings, etc. Place the receiver near the performance area (stage). Make sure, though, that the transmitter will never get any closer to the receiver than 10 ft (3 m). Check that you can see the receiver from where you will be using the transmitter. You can either use the receiver freestanding or mount it in a 19" rack using the optional RMU 60 rack mounting kit. Place the receiver with the bottom panel up on a flat surface. Slide the two supplied side panel moldings (13) with the rubber feet facing up into the fixing rails on both sides of the receiver from rear to front. Place a clamping slide (14) on each rack ear (29), checking that the pegs on the clamping slides (14) engage in the fixing holes on the rack ears (29). Slide the clamping slides (14) and rack ears (15) into the fixing rails on both sides of the receiver from rear to front. Tighten the two Phillips screws in the clamping slides (14) CW to fix the rack ears (15) on the receiver. Use the supplied screws to fix the supplied blank panel to the left or right rack ear (29). Fix one rack ear (15) to the outside panel of each receiver referring to steps 1 through 3 above. Insert a clamping slide (14) with no rack ear (15) into the fixing rails on the INSIDE PANEL of one receiver. Insert the receiver with the clamping slide (14) on its inside panel into the fixing rails on the inside panel of the other receiver. [. . . ] Use receiver and transcolor codes are not mitter with identical color identical. Move closer to receiver or from receiver or SQUELCH turn down SQUELCH concontrol set too high. Move receiver away from or metal objects. Switch off interference wireless systems, TV, radio, sources or defective appliCB radios, or defective ances or use a WMS 40 electrical appliances or tuned to a different freinstallations. [. . . ]