User manual AKG SRA 1

[. . . ] Please take a few minutes to read the instructions below carefully before operating the equipment. Please keep the manual for future reference. Have fun and remember that AKG equipment has been designed to support your creativity! [. . . ] If it does not, set the Frequency Range Selector on the antenna to its alternative position. Use the supplied SA 40 stand adapter to mount the antenna on a microphone stand making sure that the connector points straight down. ) in front of and at a minimum lateral distance of 50 cm (20 in. ) from any walls or other plane surfaces, metal grids, or metal scaffolding as shown in fig. 6 and 7, make sure the antenna will be at least 15 cm (6 in. ) if you route the cable to the antenna from above). If you set up two SRA 1 antennas side by side (e. , for diversity reception), check that the two antennas are spaced at least 20 cm (8 in. If the ceiling is high enough you can cover the entire performance area by mounting a single antenna on the ceiling and pointing it down. Make sure to fix the antenna at least 10 cm (4 in. Use suspension fixtures made of insulating materials only. 8: Minimum distance between two antennas. Aim the antenna like a spotlight at the center of the performance area (stage). Therefore, aim the antenna 5° to 20° lower than the direct line of sight to the performance area (see fig. You may also use the SRA 1 directional antenna in small rooms or on small stages where the antenna will be less than 10 m (33 ft. In receiving mode, the antenna will receive signal even from spots within the performance 2. [. . . ] Make sure that at least the first 20 cm (8 in. Otherwise the antenna's polar pattern would change. Connect the other end of the antenna cable to the antenna input of your receiver or Power Splitter. [. . . ]